Service and Parts Manual (2018, 2019, 2020, 2021, 2022)

45 PB
INSTALLATION
Install WRT2 Wireless Programmable Thermostat
Mount Transmitter Unit
1. Mount the thermostat transmitter on an inside wall about
ve feet above the oor in an area that has good circulation
but is not directly affected by a supply vent or return.
NOTE: .For optimal RF Pairing and performance, the
transmiiter should be mounted within 30 feet of the receiver,
and have a direct line of sight.
3. Mark the placement of the new mounting holes through
the thermostat base. Using a 3/16” drill bit, drill the holes
you have marked and insert the supplied wall anchors.
4. Use supplied screws to mount base to the wall.
5. Return the thermostat front cabinet to its base by hooking
the top rst and then gently swinging the bottom of the
thermostat into place.
The Transmitter should NOT be mounted:
1. Close to a window, on an outside wall, or next to a door
leading outside.
2. Where it can be exposed to direct sunlight or heat,such as
the sun, a lamp,replace or any other temperature radiating
object which may cause a false reading.
3. Close to or in the direct airow of supply registers and/or
return air grilles.
4. Any areas with poor air circulation,such as a corner,
behind a door,or an alcove.
Thermostat
Reciever
Thermostat
<30’
Transmitter
PTAC
Figure 516 (Mount Transmitter)
Figure 517 (Mount Transmitter)