Installation & Operation Manual

THINK
SAFETY
FIRST
WARNING
AVERTISSEMENT
ADVERTENCIA
Do not remove,
disable or bypass this
unit’s safety devices.
Doing so may cause,
fire, injuries or death.
No abra cuando se encuentre en
una atmósfera explosiva.
pré
ère explosive est
Ne pas ouvrir lorsque une
atmosph
sente.
No separar cuando se encuentre
bajo tensión.
To avoid the buildup
of electrostatic charge,
regularly clean the unit
with a damp cloth.
Para evitar la acumulación de
cargas electrostáticas, limpie
regularmente la unidad con un
paño húmedo.
Pour éviter l’accumulation de
charges électrostatiques,
nettoyer régulièrement l’appareil
avec un chiffon humide.
Ne pas séparer sous
tension.
Do not open when an
explosive atmosphere
is present.
Do not separate when
energized.
Ne pas supprimer, désactiver
ou contourner cette l’unité des
dispositifs de sécurité. Faire
vous risqueriez de provoquer,
le feu, les blessures ou la mort.
No eliminar, desactivar o pasar
por alto los dispositivos
de seguridad de la unidad. Si
lo hace podria producirse
fuego, lesiones o muerte.
Table of Contents
Operation and Care Instructions
Your Safety and the safety of others ...........................................................................2
General Instructions ....................................................................................................3
Filter Information .........................................................................................................4
Maintenance Checklist ................................................................................................4
Special Features .........................................................................................................5
Control Panel ............................................................................................................. 5
Underwriters Laboratories ...........................................................................................6
Installation Instructions
Electrical Requirements ...............................................................................................7
Unpacking the Unit .......................................................................................................9
Chassis Wiring and Preparation ...................................................................................9
Shell Preparation ........................................................................................................10
Shell Installation ..........................................................................................................11
Sash Window ..............................................................................................................11
Through-the-Wall ........................................................................................................14
Chassis Installation .....................................................................................................17
WARRANTY ...............................................................................................................19