Installation & Operation Manual

4
Filter Information
The filter in your Friedrich removes dust, pollen and other
impurities from the air as they are drawn through the unit.
The filter is permanent and reusable, and has a germicidal
treatment which is not affected by periodic washing.
Won’t Cool
If the unit operates, but doesn’t cool, check to see that the con-
trols are properly set. Inspect the filter and if needed, clean it
Check to see if the chassis seal gasket is installed
(refer to installation instructions).
Won’t Run
If the unit does not operate at all, check that the power supply
connections are present and tight. Check for blown fuses or
Inside Coil Freezes Up
Your Friedrich Hazardgardisdesigned nottofreezewithoutdoor
temperatures as low as 45°F (7°C). Freezing should only occur
when the outsideairisdamp and below 45°F (7°C). If theindoor
Maintenance Checklist
coilshouldiceoverwhilecooling,setthe thermostatto thewarm-
est positionuntil the ice onthe coilis gone. Settingthethermostat
toaslightlywarmerpositionwillprobably keepicefrom forming
on the coil. A dirty filter will contribute to coil icing.
Cleaning
The front grille of your Friedrich, as well as the complete cabi-
net may be cleaned with warm water and a mild detergent. The
coils and base pan should be cleaned periodically for the most
efficient operation. We suggest you call your Friedrich dealer
for this service.
Lubrication
Fan motors are factory lubricated and sealed. No lubrication
is required.
A clogged, dirty filter reduces the air flow through the unit and
reduces its efficiency. You should check the filter every seven
to ten days, depending on the amount your unit is used. Clean
the filter regularly.
FILTER RETAINER CLIPS
The lter can be removed for cleaning by opening the front of
the unit and releasing the
lter from its retaining clips.
thoroughly.
tripped circuit breakers. Replace blown fuses with the
proper size time-delay fuse.The nameplate on the unit shows
the proper fuse size. After restoring power, wait three minu-
tes before restarting the unit.