Intallation Manual

ManualsBrandsFriedrich ManualsAir ConditionersWindow or Wall Air Conditioner Cooling Area,

STEP 11. INSTALL THE WINDOW SEALING GASKETS – Measure

and cut

the

vinyl window seal gasket (grey color, Item 12) to

Pull the window sash down behind the gasket. Measure and

cut the dark foam window seal gasket (Item 13) and install it

between the upper glass panel and the top part of the lower

window sash (Figure 29).

STEP 12 Carefully team lift the chassis and set it into the cabinet. Slide

the chassis stopping approximately 3" from full insertion. Insert

the chassis seal gasket (Item 14) one inch deep between the

.82 egap no nwohs sa )92 erugiF eeS( tenibac eht dna sissahc

A paint stir stick or ruler might be helpful here. Begin inserting

the gasket at either bottom corner and go up the side, across

the top, and down the opposite side. Then push the chassis

all the way into the cabinet.

NOTE:

If the chassis seal gasket is not installed or installed improperly,

the operation of the unit will be negatively affected. Operational

STEP 13. Reattach the entry guard chassis entry guard retainer wire with

the same screw retained in Step 1 (See Figure 14).

CAUTION

Excessive Weight Hazard

Use two or more people when

installing your air conditioner.

Failure to do so can result in

back or other injury.

CAUTION

Cut/Sever

Although great care has been

taken to minimize sharp edges

in the construction of your unit,

use gloves or other hand

protection when handling unit

Failure to do so can result in minor

to moderate personal injury.

STEP

10.

INSTALL THE R1 INSULATION PANEL – To

minimize air leaks and ensure optimal insulation, install the

included R1 insulation panel. (14 in parts list) (See Figure

below A-C).

First, measure the width from one side of the cabinet/sleeve

(covering the side angles where the wingboard was just

secured) to the end of the wingboard. (See Figure A)

Next cut the R1 insulation panel to the measured width and

remove protective cover, exposing adhesive on back panel

(See Figure B)

Last, evenly apply the adhesive side of the panel across the

entire height and width from side angle to wingboard panel.

(See Figure C)

Repeat the steps above for the other wingboard panel.





INSERT FOAM WINDOW

SEAL GASKET (ITEM 12)