Kuhl Colored Front Installation Manual

ManualsBrandsFriedrich ManualsAir ConditionersWindow or Wall Air Conditioner Cooling Area, Adjustable Air Direction

Installation Instructions

Kühl Color Kit

For Use with Kühl and Kühl+ units

Please read these instructions completely before attempting installation.

NOTE: These instructions apply to the Friedrich Kühl Series.

Kit Contents: Quantity

Door Decorative Front (Size & Color)

Top Decorative Cover (Top Cover)

Hinge Pin

Tool Top Cap Removal (Screwdriver)

Instruction Sheet

Tools Required: Friedrich supplied screwdriver

Step 1. Front cover removal and install:

Please use the provided screwdriver to release top decorative cover free from unit’s decorative front.

This is accomplished by positioning the flat blade of the screwdriver into the seam (about 1” from end)

between the top cover and the decorative front. Be careful not to apply pressure to the front

horizontal louver (vents) while releasing the top cover. The top cover has 4 tab locks which hold it in

position. By inserting the blade slightly and gently twisting the tab lock can be released. Work from

the left side to the right side releasing the lock tabs until the top cover cap is loose.

Model Kühl Series

92003705_00 (5-10) Friedrich Air Conditioning Co. Page 1 of 4

Post Office Box 1540 / San Antonio, Texas 78295-1540

(210) 357-4400 / (800) 541-6645 / www.friedrich.com

TAB LOCKS (4)

NOTE: Gently slide top

cover forward

Summary of content (4 pages)

PAGE 1
Model Kühl Series Installation Instructions Kühl Color Kit For Use with Kühl and Kühl+ units Please read these instructions completely before attempting installation. NOTE: These instructions apply to the Friedrich Kühl Series. Kit Contents: Quantity Door Decorative Front (Size & Color) Top Decorative Cover (Top Cover) Hinge Pin Tool Top Cap Removal (Screwdriver) Instruction Sheet 1 1 2 1 1 Tools Required: Friedrich supplied screwdriver Step 1.
PAGE 2
Model Kühl Series Next, with the top cover cap still in place, slide it toward you until it is free from the unit decorative front. Unpack the new top cover. Note that it has interlock ribs on its bottom side which will slide in to the channels located on the top of the decorative front top surface. Carefully align the new top cover cap interlocking rib to enter the decorative front receiving channel and push the top cap cover to fully engage the interlock rib to the channel.
PAGE 3
Model Kühl Series The decorative front filter access door can be easily removed by utilizing the small screwdriver again. Open the door completely and observe the hinge pins near the inside bottom left and right corners of the door. Gently pry the hinge pin to cause it to rotate upward. Once the hinge pin is rotated clear of the doors’ locking rib it can be removed. Gently pull the hinge pin to the side to remove it from the door and the decorative front.
PAGE 4
Model Kühl Series Carefully position the new decorative door to the decorative front and while holding it in place, insert a hinge and rotate its position to lock it into place. Next insert the other hinge pin to the opposite end and rotate it to lock it into position. The new decorative door is now installed. 92003705_00 (5-10) Friedrich Air Conditioning Co. Post Office Box 1540 / San Antonio, Texas 78295-1540 (210) 357-4400 / (800) 541-6645 / www.friedrich.