Room Air Conditioner Installation and Operation Manual Slider Casement 115 Volts • SV08A10A _P_To_ II.
FOR YOUR RECORDS Write the model and serial numbers here: Model # Serial # You can find them on a label on the side of each unit. Dealer's Name Date Purchased • Staple your receipt to this page in the event you need to prove date of purchase or for warranty it issues. aO READ THIS MANUAL Inside you will find many helpful hints on how to use and maintain your air conditioner properly.
Safety Precautions To prevent injury and property damage, follow these instructions. • Incorrect operation due to ignoring instructions may cause harm or damage, the seriousness of which is indicated by the following symbols. ;¢;_%y N ,_W,8,,RN_NG &CAUTION This symbol symbol indicates indicates the thepossibility possibilityof of death or seriousto properties injury. This injury or damage only. | • Meanings of other symbols used: Be sure Never do this. to follow the instruction.
Safety Precautions • Operation • Otherwise, it may cause electric shock or fire due to heat generation. • Doing so may cause electric shock or fire due to heat generation. • Doing so may cause electric shock or fire due to heat • Doing so may cause electric shock or fire. generation. • Doing so may cause electric shock or fire due to heat generation. • No grounding may cause electric shock (See Installation instructions plO). ® • Not doing so may cause electric shock or fire.
Safety Precautions • Doing so may cause failure of machine or electric shock. • It is not designed to cool the entire house. • Installation • They are sharp and may cause injury. • It may cause failure of appliance or accident. • Using a damaged outer case may hinder airflow or cause the chassis to fall. • It may cause injury. • Improper handling may cause electric shock or damage. • Prevent accidental startup and the possibility of injury.
Safety Precautions • Operation • There is danger of fire or electric shock. • Since the fan rotates at high speed during operation, it may • Water may enter the unit and degrade the insulation. It may also cause an electric shock. • This could injure the pet or plant. • It is an air conditioner, not a precision refrigeration system. cause injury. i..... ® • Operation without filters will cause failure.
Priorto Operation 1. 2. 3. 4. Contact an installation specialist Plug in the power plug properly. Use a dedicated circuit. Do not use an extension cord. for installation. 5. Do not start/stop operation by plugging/unplugging the power cord. 6. If the cord/plug is damaged, only replace it with an authorized replacement part. 1. Being exposed to direct airflow for an extended period of time could be hazardous to your health.
Introduction _k_ This symbol alerts you to the risk of electric shock. This symbol alerts you to hazards the air conditioner. This symbol indicates special that could cause harm to notes. AWARNING This appliance should be installed in accordance with the National Electric Code.
ElectricalSafety 115V~ 230V- Power cord may include a current interrupter device. A test and reset button is provided on the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button. If the TEST button does not ii [ ill trip or if the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician. The shape may be different according to its model.
ElectricalSafety IMPORTANT (PLEASE READ CAREFULLY) FOR THE USER'S PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED A. SITUATIONS WHEN THE APPLIANCE WILL BE DISCONNECTED OCCASIONALLY: Because of potential safety hazards, we strongly discourage the use of an adapter plug. However, if you wish to use an adapter, a TEMPORARY CONNECTION may be made. Use UL-listed adapter, available from most local hardware stores.
Installation NO. 1 2 1. These instructions are for a horizontal sliding or a casement window. 2. The electrical outlet must be within reach of the power cord.
Installation 1. To prevent vibration and noise, make sure the unit is installed securely and firmly 2. Install the unit where the sunlight does not shine directly on the unit. Awning Fence Cooled air Heat radiation 3. The outside of the cabinet must extend outward for at least 14" and there should be no obstacles, such as a fence or wall, within 20" from the back of the cabinet because it will Over 20" prevent heat radiation of the condenser.
Installation 1. Loosely attach the Support Bracket to the bottom of Bracket using Bolts, Washer, and Nuts. Attach the Leveling Bolt and Nut. (Fig. Bracket 1) 2. Remove protective backing from Window Track Seal and apply seal to window track. Leveling Bolt & Nut Support Fig. 1 (Fig.2) I lamb 3. Measure and lightly mark a line 8-1/4 inches from window jamb. Center the Support Bracket assembly on the window track and fasten with 4 Type C screws.(Fig. 2) i 1 I /4 i Inch a: Seal Track 4.
Installation 7. Measure height of window opening from top of Bracket assembly as shown Fig. 5. Subtract 20-3/4 inches. Mark this measurement on Curtain and cut the Curtain. (Fig. 5) Fig. 5 8. Slide Curtain into Curtain Frame. Slide Curtain Frame assembly into side Guides of the Air Conditioner cabinet. Make sure Curtain is firmly enclosed on all sides by the Frame. (Fig. 6) me Curtain Curtain_ig. 6 9. Cut side Guide seal into 2 equal lengths.
Installation seal strip Check all seals and plug any remaining air gaps with a suitable weatherproof caulk. 14. If this is a casement window installation, proceed to Casement Window Installation. If not, stuff the Foam Seal Strip between the vertical sash and the window glass. (Fig. 9) 15. Attach the L Bracket with a Type B screw. locking bracket (Fig. 9) Fig. 9 1. Installation procedure is the same as that described in steps 1 through 11 and step 13 of the Horizontal Sliding Window installation. 2.
OperatingInstructions A CAUTION When the air conditioner has been performing its cooling operation and is turned off or set to the fan position, wait at least 3 minutes before resetting to cooling mode again. OFF- Turns air conditioner off. Med High MEOFAN - Med speed fan operation without cooling. LOWFAN - Low speed fan operation without cooling. Fai_T_i°°lj Lo Fan H_ Cooling with high speed fan operation. COOL - _ Me_ MEO Cooling with med speed fan operation.
OperatingInstructions Additional controls and important information. The ventilation lever must be in the CLOSE position in order to maintain the best cooling conditions. When fresh air is necessary in the room, set the ventilation lever to the OPEN position. The damper is then opened and room air is exchanged with external air. CLOSE-L VENT-LOPEN The direction of air can be controlled by adjusting the horizontal and vertical louvers.
Maintenance andService TURN THE AIRCONDITIONER OFFANDREMOVE THEPLUG FROM THEPOWER OUTLET. The air filter behind the front grille should be checked and cleaned at least once every 2 weeks or more often if necessary. To remove: 1. Open the inlet grille downward by pulling out the top of the inlet grille. 2. Remove the air filter from the front grille assembly by pulling the air filter up and out. 3. Clean the filter with warm, soapy water. 4.
Maintenance andService Before calling for service If you have problems with your air conditioner, read the following information and try to solve the problem. If you cannot find a solution, turn off the air conditioner and contact your dealer. Air conditioner does not operate 1. Ensure that the air conditioner is plugged into a proper outlet. 2. Check the fuse or circuit breaker. 3. Check whether Air does the voltage is unusually not feel cold enough 1. Ensure that the temperature high or low.
Maintenance andService The air conditioner may be operating abnormally when: • Make sure the plug is completely plugged into the outlet. • Check the fuse/circuit breaker box and replace the fuse or reset the breaker. The air conditioner does not operate at all • In the event of a power failure, set the power control to OFE When the power is restored, wait 3 minutes to restart the air conditioner to prevent the compressor from overloading. • Press the RESET button located on the power cord plug.
m m m m FRIEDRICH AIR CONDITIONING CO. Post Office Box 1540 • San Antonio, Texas 78295-1540 (2 ] 0) 357-4400 • FAX (210) 357-4490 ROOM AIR CONDITIONERS LIMITED WARRANTY FIRST YEAR ANY PART: If ally part supplied by FRIEDRICH fails because of a defect in workmanship or material within twelve months from date of original purchase, FRIEDRICH will repair the product at no charge, provided room air conditioner is reasonably accessible for service.
Memo 22 Room Air Conditioner
m m ,,r#edTr#cn® FRIEDRICH m m AIR CONDITIONING CO. Visit our web site at www.friedrich.com Post Office Box 1540 • 4200 N. Pan Am Expressway • San Antonio, Texas 78295-1540 • (210) 357-4400 • FAX (210) 357-4490 P/NO.: 3828A20291P _Y.
