Manual

Appendix B (Continued)
Not to scale
NOTE: If the unit is mounted flush to the floor,
the service cord MUST be rerouted through the
side of the front panel closest to the receptacle.
A notch MUST be made in the front panel side
where the cord exits the unit. It is the
responsibility of the installer to create an exit
notch. See diagram for suggested opening size
and placement.
10.
Plug the cord (if applicable) into the appropri-
ate receptacle. Extra cord may be coiled inside
front panel behind the return air louver. Restore
power to the unit.
Central Desk Control Operation
Units equipped with Central Desk Control are identical in operation with non-Central Desk Control models,
except in the "Unoccupied Mode" when all functions are disabled.
All conditions are with 24V power ON at Central Desk Control terminal board.
IMPORTANT: Even if Central Desk Control is energized, the low temperature sensor will not
allow the temperature in the room to fall below 43 ° F. If the temperature falls below 43 ° F,
heat will come on until room temperature reaches 58 ° E