Manual

Suffocation hazard.
Keep bag away from babies and children.
Do NOT use in cribs, beds or playpens, Destroy
immediately after opening. This bag is NOT a toy!
Failure to do so can result in personal injury and/or
death.
CONTROL
PIN'( DOOR
2,
Remove the front panel (contained in a protective
plastic bag) from chassis. Remove the bag and
dispose of it properly. Install the control door as
per instructions.
To install,follow these steps:
• Insert the control door into the front panel from the
back side of panel.
From the frontofthe panel, slide the right control
door pin into the hole on right side of the front panel.
Slide the left door pin into the slot on the left of the
front panel opening and snap it into place.
CAUTION
To avoid breaking the door or hinge pins, do not
apply excessive force when installing.
4.
Com#reseor
Center the chassis in the pre-installed
sleeve and carefully push the chassis until
the chassis flange and gasket contact the
sleeve flange.
CAUTION
Copper refrigerant tubes are NOT
handles. Do NOT use tubing to lift
or move chassis.
Sleeve Flange
\
3. Remove the two chassis shipping brackets from the
corner of the shipping pallet.
®
Wall Sleeve
. Locate the four #10 x 1" chassis mount-
ing screws and tighten them into the clips
in the wall sleeve flange, (two per side).
Chassis Flange
If a Remote Thermostat is to be installed, proceed to Appendix A, Step 6.
If Central Desk Control is to be installed, proceed to Appendix B, Step 6.
rl'T