Accessory UXAA Architectural Grille Manual (2019)

INSTALLATION INSTRUCTIONS

ARCHITECTURAL GRILLE MODEL UXAA/UXSC

These instructions cover the installation on an Architectural Grille, Model UXAA/UXSC, into a Unifit model solid-side

sleeve. The Architectural Grille must be installed just prior to the installation of the air conditioner chassis.

The contents of the package are:

1. UX Architectural Grille

2. All thread studs (4 each)

3. Washers (4 each)

4. Nuts (4 each)

5. Instructions

Tool required for installation: A flat-blade screwdriver or 1/4" hex. nut driver.

STEP 1.

Unifit sleeve should have been installed as specified in the Sleeve Installation Instructions. Remove

the front closure panel, louvered metal grille, and back weather panel in the sleeve. Should the air

conditioner chassis be in the sleeve, remove the chassis and the louvered metal grille using proper

procedures. See Figure 1

FIGURE 1

93063000_00 (2-13)

PAGE 1
INSTALLATION INSTRUCTIONS ARCHITECTURAL GRILLE MODEL UXAA/UXSC These instructions cover the installation on an Architectural Grille, Model UXAA/UXSC, into a Unifit model solid-side sleeve. The Architectural Grille must be installed just prior to the installation of the air conditioner chassis. The contents of the package are: 1. UX Architectural Grille 2. All thread studs (4 each) 3. Washers (4 each) 4. Nuts (4 each) 5. Instructions Tool required for installation: A flat-blade screwdriver or 1/4" hex.
PAGE 2
STEP 2. Install Grille — See Figure 2. A. Screw the 4 all thread studs into the 4 holes in the Architectural Louvered Grille. Pass grille through rear opening. Locate the grille such that the louvers are pointing to the outside and down. The mounting holes in the left and right vertical rails must match up with the open holes in the shell tabs. Fasten the grille with the washers and nuts provided. B. Remove the zip tie from the louver. C.