Accessory VPAL2 Manual (2020)

Parts included in this kit:

A) 1 - Aluminum Architectural Louver

B) 4 - Attachment Screws (located in a plastic bag taped to the louver)

IMPORTANT: The VPAL2 Architectural Louver is best installed onto the Outside Plenum

(Part A) PRIOR to the Wall Plenum installation. The louver installation is easier at this

point, and it will help keep the Wall Plenum square during installation.

INSTALLATION OF THE LOUVER PRIOR TO VPAWP WALL PLENUM INSTALLATION

Hold the louver up to the Outside Wall Plenum Part A (see the VPAWP instructions) and line up the louver top with the

very top edge of the 3/4" flange. Line up the VPAWP holes with the threaded holes in the louver, install and tighten

the four screws. Note that there are eight flange holes, however, only the four inside holes are used.

Installation Instructions

ARCHITECTURAL LOUVER

For Use With Vert-I-Pak Units

Please read these instructions completely before attempting installation.

NOTE: These instructions apply to Vert-I-Pak Units ONLY. Refer to Chassis Installation/Operation Manual for additional

information.

Model VPAL2

920-077-01 (10-04)

PAGE 1
Model VPAL2 Installation Instructions ARCHITECTURAL LOUVER For Use With Vert-I-Pak Units Please read these instructions completely before attempting installation. NOTE: These instructions apply to Vert-I-Pak Units ONLY. Refer to Chassis Installation/Operation Manual for additional information. IMPORTANT: The VPAL2 Architectural Louver is best installed onto the Outside Plenum (Part A) PRIOR to the Wall Plenum installation.
PAGE 2
INSTALLATION OF THE LOUVER AFTER INSTALLATION OF THE VPAWP WALL PLENUM For safety, tie a rope or tether to the Architectural Louver, then to the divider in the Wall Plenum. This will prevent the louver from falling from the building if it is dropped. From inside the utility closet: A) Grasp the louver as shown in the illustration. B) Turn the louver sideways and push the louver out the bottom opening in the Wall Plenum. C) Pull the louver back against the Wall Plenum and align the four holes.