Accessory VPAWP Manual (2020)

Step 6: Adjust the Divider

NOTE Let the caulk cure completely before installing

the chassis. This completes the plenum installation.

Adjustment

Loosen the two screws located on the top side of the divider.

Slide the top part of the divider toward the outside until the

sealing strip makes contact with the outdoor louver. Tighten

the divider screws to complete the adjustment.

Condensate Disposal Preparation

for VHA09 and VHA12 Models

IMPORTANT This step must be performed to ensure that the

chassis installs and seals properly in the wall plenum.

If provisions for condensate disposal are made prior to chassis

installation and the drain is to be located beneath the platform

for the unit, use the accompanying drawing as a guide for cut-

out locations. Only one drain per unit is required.