Installation & Operation Manual (2019)

17
Drain Kit Installation
A
Step 4 - VPDP1 Installation
NOTE: VPDP1 (Drain Kit) should be installed prior to the installation of the chassis.
1. Cut the weather seal gasket at the left corner of the plenum.
2. From the initial cut, measure 8” toward the center of the plenum and make a second cut.
3. Peel away the cut section of gasket from the plenum surface.
4. Run a 1/4” bead of sealent the entire width of the removed gasket.
5. Insert the drain kit with the overow lip toward the plenum and ensure it is ush.
6. Finish installation with the eld supplied parts.