Installation Instruction Architectural Grille Guide

STEP 3. Install Grille — See Figure 2.
A. If the sleeve is installed in a wall above the ground fl oor, tie the fi ber strap provided to one of the
horizontal louvers. Tie the other end to any stationary object to prevent damage or injury if the grille is
accidentally dropped.
B. Pass the grille out through the rear opening. Locate the grille so that the louvers are pointing to the
outside and down. The mounting holes in the left and right vertical rails must match up with the open
holes in the brackets. Fasten the grille with the remaining screws provided. Tighten the screws.
C. Remove the fi ber strap.
D. Slide the air conditioner chassis into the sleeve according to the chassis instructions.
FIGURE 2
IMPORTANT: Install
with the louvers
angled down.
Friedrich Air Conditioning Co.
Post Office Box 1540 • San Antonio, Texas 78295-1540
4200 N. Pan Am Expressway • San Antonio, Texas 78218-5212
[phone] • FAX [phone]
www.friedrich.com
617-408-01 (7-05)