Wi-Fi Operation Manual
Table Of Contents
- INTRODUCTION
- IMPORTANT SAFETY INFORMATION
- PERSONAL INJURY OR DEATH HAZARDS
- FCC Caution
- Kuhl, Kuhl Q, And Wallmaster Controls
- KUHL, KUHL Q, AND WALLMASTER
- Wi-Fi SET UP INSTRUCTIONS
- Wi-Fi TROUBLESHOOTING TIPS
- FA Pro/ FA Premier App Info
- FA Pro, FA Premier Troubleshooting
- Chill Premier/ Unifit App Info
- Chill Premier/ Unifit Registration
- Chill Premier/ Unifit Login
- Chill Premier/ Unifit Troubleshooting
6 PB
FRIEDRICH CONNECT
Kuhl, Kuhl Q, And Wallmaster Controls
All of the control panel function buttons and mode icons can be viewed in Figures 201.
Power On – Press the button to turn on the air conditioner. The power button illuminates to in-
dicate that the power is on. The backlight on the power switch will automatically turn o after 20
seconds of inactivity. The remote control can also be used to turn power ON / OFF.
Display – The display is a high eciency LCD with a built-in backlight. After 20 seconds of
inactivity, the display switches o. Touching any button automatically changes the display to full
brightness.
There are three control push buttons on each side of the display.
CONTROL PANEL AND DISPLAY
Figure 201
-AUTO-
Automatically switches
between cool & heat
CONTROL
LOCKED
WI-FI OPERATING
STATE
TEMPERATURE
UP
TEMPERATURE
DOWN
2 DIGIT DISPLAY
Shows Setting for:
- Set Point (Temperature)
- Clock (AM/PM)
FILTER
Check / clean
FAN SPEED
Sets fan speed:
LOW, MED, HIGH,
or MAX (Selected
Models Only)
FAN
Sets fan to either:
- Automatically cycle
- Continuously run
COOL HEAT FAN ONLY DISCONNECTED FROM
POWER BOARD
MODE
Cycles between
COOL, HEAT, FAN
ONLY or -AUTO-
(if equipped)
ON / OFF
Turns unit on/off
TIMER
shows on or off