WallMaster Installation and Operation Manual

6
To set the timer
NOTE: You can set the START and STOP times a minimum
of one hour apart, and a maximum of 23 hours apart.
10
TIMER START - Press Start to view the current start time for
cooling. Continue pressing the START button until you arrive
at the start time you desire. The start time for cooling will
then be set.
11
TIMER STOP - Press the Stop button. Continue pressing
the STOP button until you arrive at the stop time you
desire. The stop time for cooling will then be set.
12
TIMER ON / OFF - Press the On/Off button (under
Timer Operation) to activate (light on) or deactivate (light
off) the timer. Once the on and off times have been
selected, they will remain in memory and cycle daily until
changed.
Additional RC1 wireless remote controls can be purchased from your Friedrich dealer.
NOTE: If the unit is unplugged or the power is interrupted, the
Set Hour . function must be reset or the
Timer On/Off
function will
not work.
Figure 3
WY/WE heat-cool model remote control
How to clean the air fi lter
Your Friedrich room air conditioner is equipped with
a permanent/washable mesh air filter. The filter serves to
remove dust, pollen, and other impurities from the air.
FILTER ACCESS
Remove the FRONT PANEL. Using the handles, pull
panel out until it is released from the two retaining
snaps. Place the cover aside carefully.Remove the filter by
pulling it from the handles releasing it from the slots on the
frame. Wash the filter with water to remove all dust and
then rinse, remove water excess and let it dry – do not
twist – then replace the filter by inserting each tab in
their respective slot.
Replace the FRONT PANEL by positioning one of the sides
in the snaps of the handle first and then the other side,
make sure that both snaps are correctly aligned and the
Logo is in the right position.
CHECK FILTER LIGHT
Your Friedrich room air conditioner is equipped with a check
filter light that will illuminate after *45-60 days of
fan operation.
*Actual timer is set for 1000 hours of fan cycle operation.
Figure 4
To reset the CHECK FILTER reminder press the CHECK
FILTER button. (While the reminder is set for 45-60 days of
operation, we recommend checking the filter every 30 days
for optimal performance.)