User's Manual
Table Of Contents
- About This Document
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 2.1 General Description
- 1.1 Simplified Block Diagram
- 1.2 Features and Application
- 1.3 Evaluation Board
- 1.4 List of Applicable FCC Rules
- 1.5 The Specific Operational Use Conditions
- 1.6 Limited Module Procedures
- 1.7 Trace Antenna Designs
- 1.8 Antennas
- 1.9 Label and Compliance Information
- 1.10 Information on Test Modes and Additional Testing R
- 2 Pin Definitions
- 3 Technical Specifications
- 4 Application Interface
- 5 Application Function
- 6 Data Business
- 7 Mechanical Dimensions
- 8 Appendix
WSL05-A0_User_Manual
Page
14
/
58
1.4 List of Applicable FCC Rules
FCC Part 15 Subpart C 15.245 &15.207 &15.209.
1.5 The Specific Operational Use Conditions
The module is a with communication functions.
Operation frequency: 902-928MHZ
Number of channel:72
Modulation:LORAWAN
The module can be used for mobile or portable applications. The host manufacturer
installing this module into their product must ensure that the final composite product
complies with the FCC requirements by a technical assessment or evaluation to the FCC
rules, including the transmitter operation. The host manufacturer has to be aware not to
provide information to the end user regarding how to install or remove this RF module in the
user's manual of the end product which integrates this module. The end user manual shall
include all required regulatory information/warning as show in this manual.
1.6 Limited Module Procedures
This module is a non-restricted module and meets the requirements of non-restricted
module certification.
1.7
Trace Antenna Designs
The module come with a detachable split antenna. The connection area between the module and the antenna is
A1.
The RF line (the line between the module and the antenna) is 52 ohms, the line width is 12 mils, and the line
length is 50 mils. The PAD size, length*width=50mil*42mil.
A1 Area
The RF line
length*wi
dth=50mil
*12mil
The PAD
size