User's Manual
Table Of Contents
- About This Document
- Table Index
- Figure Index
- 1 Introduction
- 2 Product Concept
- 2.1 General Description
- 1.1 Simplified Block Diagram
- 1.2 Features and Application
- 1.3 Evaluation Board
- 1.4 List of Applicable FCC Rules
- 1.5 The Specific Operational Use Conditions
- 1.6 Limited Module Procedures
- 1.7 Trace Antenna Designs
- 1.8 Antennas
- 1.9 Label and Compliance Information
- 1.10 Information on Test Modes and Additional Testing R
- 2 Pin Definitions
- 3 Technical Specifications
- 4 Application Interface
- 5 Application Function
- 6 Data Business
- 7 Mechanical Dimensions
- 8 Appendix
WSL05-A0_User_Manual
Page
36
/
58
Configure AppEui, AppKey and other parameters of the module.
Set OTAA activation mode.
Delete the session context of module and set AutoJoin flag.
Enable hot start.
Save parameters.
After the configuration is complete, the Join operation can be performed automatically
after the module is reset.
View an example of activation configuration for OTAA mode:
AT+DEVEUI=1122334455667788
OK
AT+APPEUI=1234567812345678
OK
AT+APPKEY=00112233445566778899AABBCCDDEEFF
OK
AT+JOINMODE=0
OK
AT+JOIN=0,1
OK
AT+HOTS=1
OK
AT+SAVE
OK
AT+RESET
OK
5.3.2 ABP Mode
ABP activation mode is to simulate activation operation by directly configuring same
session context on server and module. ABP mode does not need to send a Join request to
server, thereby simplifying the activation process.Activation process in ABP mode is as
following:
First register module information on server, namely, add ABP device, set DevAddr,
NwkSKey, AppSKey, frequency band and other parameters.
The DevAddr, NwkSKey and AppSKey parameters of the configuration module are the