Use and Care Manual

39
OVEN CONTROLS
Setting a Delay Start Self Clean Cycle
The self clean and delay start keys control the delayed
self-clean operation. The automatic timer will turn the oven
on and off at the time you select in advance.
To set the control for the self cleaning cycle to start at a
dela
yed time and shut off automatically (example: 3
hour self clean cycle to start at 4:30):
1. Be
sure the clock is set with the correct time of day and
the oven door is closed.
2. Press s
elf clean. CLn and 3:00 HR will show in the
display. The control will automatically clean for a 3 hour
period. If a 2 or 4 hour clean time is desired, press self
clean multiple times to toggle between 2, 3, or 4 hours.
3. Press s
tart. door Loc will appear, a beep will sound,
and the word DOOR and the lock icon will flash. The
letters CLn
will remain on in the display.
4. As so
on as the control is set, the motor driven oven
door lock will begin to close automatically. Once the
door has been locked, the word DOOR and the lock
icon indicator light will quit flas
hing and remain on.
5. Press d
elay start. Enter the desired start time using the
number keys 4 3 0.
6. Press st
art. DELAY, DOOR, and the icons will
remain on.
7. The
control will start the self-cleaning at the set start
time for the period of time previously selected. At that
time, the icon DELAY will go out; CLn and oven icon
will appear in the display.
When the self-clean cycle is completed:
1. HOT
will appear in the display. The time of day, the
word DOOR, and the lock icon will remain in the display.
2. Wh
en oven cools approximately 1 HOUR, door OPn
will appear, and the word DOOR and the icon will
flash until the door is unlocked.
If your clock is set with the (default) 12hr display mode,
the Delay Start for a Self Clean can only be programmed
to start up to 11 hours and 59 minutes after the time
showing in the display. Be sure to set the time of day to
the current time before programming.
To set a Delay Start Self Clean to begin 12 or more hours
(the ma
ximum is 23 hours and 59 minutes) after the time
of setting the Self Clean, be sure to first set the control to
the 24 hour display mode.
NOTE
Do not attempt to force the door open while self clean is
active or when the motor door latch is unlocking or the
door lock indicator is flashing. Once the display is clear,
the oven door can then be opened, and the timer will
revert back to the time of day.
If Self Clean was active and then interrupted by a power
fail
ure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run another Self Clean
cycle.
If the oven temperature was high enough when the Self
Clean was interrupted, the oven control may not allow
another Self Clean to be set for up to 4 hours.
IMPORTANT
NOTE