Use and Care Guide

19
TROUBLESHOOTING
Dishwasher Won’t Run
Check to see if circuit breaker is
tripped or if a fuse is blown.
Make sure water supply is turned on.
Check to see if cycle is set correctly.
(See Operating Instructions).
Is dishwasher set for Delay Start
Option?
Make sure START/Cancel button
is pressed after cycle has been
selected.
Make sure door is closed and latched
immediately after pressing the
START/Cancel button
Dishwasher Won’t Fill
Assure the water supply is turned on.
Check that the overfill protector
moves up and down freely. (See
Overfill Protector section).
Dishwasher Does Not Drain Properly
If unit is hooked up to a food waste
disposer, make sure the disposer is
empty.
Assure the knockout plug has been
removed from inside the food waste
disposer inlet.
Assure the drain hose isn’t kinked.
Make sure cycle is complete, not in a
pause.
Assure the glass trap is maintained
and installed properly assuring no
clogs (See Care and Cleaning).
Dishwasher has an Odor
Soiled dishes left in dishwasher too
long can create an odor. Use Rinse
Only cycle.
There will be a “new” smell when first
installed. This is normal.
Check to see if unit is draining
properly. (See Dishwasher Does Not
Drain Properly).
Stains on Tub Interior
Washing large amounts of dishware
with tomato based soil can cause
a pink/orange appearance. This
will not aect performance and
will gradually fade over time. Pre-
rinsing or using the Rinse Only cycle
will reduce the chance of staining.
Using no heat dry option will lessen
staining.
Opening the door during cycle
If the dishwasher door is opened
while the unit is running, the START/
Cancel button must be pressed and
the door shut immediately to return
the unit to the selected cycle and
option, this must happen within 10
minutes for the unit to continue the
cycle.
Removing Spots and Film
Hard water can cause lime deposit
buildup on the interior of the dishwasher.
Dishes and glasses may also get spots
and film for a number of reasons. (See
Glassware/Flatware Spotted or Cloudy
section). To remove buildup, and film,
clean using the following instructions:
1. Load clean dishes and glasses in
normal manner. Do not load any
metal utensils or silverware.
2. Do not add detergent.
3. Select the NORMAL WASH cycle.
Press START/Cancel button. Close
the door.
4. Allow dishwasher to run until
it starts the second water fill
(approximately 8 minutes).
5. Open the door, pour 2 cups of
white vinegar into the bottom of
dishwasher.
6. Press START/Cancel button. Close
the door and allow cycle to finish.