Installation Guide

Installation Instructions
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Microwave Oven Top
Attach the microwave oven to the top cabinet.
Equivalent to
Depth of Cabinet
Recess
3
MOUNT THE MICROWAVE OVEN
Self-Aligning Screw
4
2
Rotate front of oven
up against cabinet
bottom.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least t
wo full turns after
the threads have engaged. (It will be
completely tightened later.) Be sure to keep
power cord tight. Be careful not to pinch the
cord, especially when mounting flush to bottom
of cabinet.
NOTE: When mounting the
microwave oven, thread
p
ower cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps
1–3. Do not pinch cord or
lift oven by pulling cord.
Lift microwave, tilt
it for
ward, and hook
slots at back bottom
edge onto four
lower tabs of
mounting plate.
1
CHECK BLOWER PLATE
Blower Plate
• Place the microwave in its upright position, with
the
top of the unit facing up.
• Check to see that the blower plate is
correctly installed on the unit.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
• Read the instructions on the TOP CABINET
TEMPLATE.
• T
ape it underneath the top cabinet.
• D
r
ill
th
e
holes, following the instructions on
the TOP CABINET TEMPLATE.
C
A
U
T
I
ON: Wear safety goggles when drilling
holes in the cabinet bottom.
You need to drill holes for the top support screws
and a hole large enough for the power cord to fit
through.
NOTE: Adjust top template accordingly if the
microwave is being spaced out from the wall due to
cabinet depth (including cabinet doors) of more than
13".
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use the
handle or heat shield during installation.
Do not remove the cardboard spacers
between the heat shield and door.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
A2.
A3.
A4.
EN-11