Installation Guide

EN-12
Installation Instructions
5
MOUNT THE MICROWAVE
OVEN (cont.)
8
7
Tighten the outer two screws to the top
of the microwave oven. (While tightening
screws, hold the microwave oven in place
against the wall and the top cabinet.)
Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
Tighten center
screw completely.
Install grease filters. See the Use
and Care
packed with the microwave.
INSTALLING OR CHANGE
THE CHARCOAL FILTER
(Some Models)
A 5.1
Unplug microwave oven or disconnect power.
Remove the charcoal filter by pushing
the top of the filter inwards,then pull
it forward out from the unit.
Slide the top of the new charcoal filter
into the top of the filter cavity.
NOTE: The charcoal filter is factory installed in
some models. Refer to the Use and Care to see if
yours is factory installed and for replacement
information.
For models without the recirculation filter access
door,follow these steps to replace or install a
charcoal filter.
A4.
A5.
A 5.2
A 5.3
A 5.4
6
Open the microwave door and push
the “PUSH”
position on the Vent, and
then the
cover open.