Installation Guide

ATTACH THE MOUNTING
PLATE TO THE WALL
B3.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling
holes in the cabinet bottom.
Wall
Mounting
Plate
Toggl
e
Bolt
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
To use toggle bolts:
Bolt End
Installation Instructions
Attach the plate to the wall using toggle
bolts. At least one wood screw must be used
to attach the plate to a wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to
3
⁄4″ (19
mm) onto
each bolt.
1
2
Place
the mounting plate against the wall and
insert the toggle wings into the holes in the
wall to mount the plate.
NOTE: Before tightening
toggle bolts and wood
screw, make sure the bottom of the mounting
plate touch the bottom of the cabinet when
pushed flush against the wall and that the plate is
properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the
wall.
Tighten all bolts. Pull the plate away from the
wall t
o help tighten the bolts.
3
4
2
1
Remove and save screw that holds blower
motor to microwave.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
B5.
End B
E
nd A
Back of
Microwave
Blower Motor
Blower
Mot
or Screw
Carefully pull out the blower unit. The
wires will extend far enough to allow you
to adjust the blower unit.
Before: Fan
Blade Openings
Facing Forward
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
B4.
You need to drill holes for the top support
screws and a hole large enough for the power
cord to fit through.
Back of
Microwave
Roll the blower unit 90°
Back of
Microwave
3
Before Rotation After Rotation
EN-17