Installation Guide

AF
TER: Fan Blade
Openings Facing Back
P
lace the blower unit back into the opening.
Replace the blower plate in the same
position as before with the s
crew. Make
sure the screw is tight.
Attach the exhaust adaptor to the rear of
the oven by sliding it into the guides at the
top center of the back of the oven.
Ro
ll the blower unit 90° so that fan
blade openings are facing out the
back of the microwave.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
B
5.
Ro
tate blower unit counterclockwise 180°.
Before Rotation After Rotat
ion
Gently remove the wires from t
he
grooves. Reroute the wires through
grooves on other side of the blower unit.
Before Rerouting After Rerouting
Wires Routed Through Right Side
Wires Routed Through Left Side
Back of
Microwave
Back of
Microwave
Blower Plate
Blower Motor
Screw
Before Rolling After Rolling
Back of
Microwave
End A
End B
Back of
Microwave
Back of
Microwave
C
AUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly
secured.
NOTE: The blower unit exhaust openings
should match exhaust openings on rear of
microwave oven.
Secure the blower unit to the microwave
with the original screw.
I
nstallation Instructions
P
ush in securely until it is in the lower locking
tabs. Take care to assure that the damper
hinge is installed so that it is at the top and
that the damper swings freely.
G
uide
Gu
ide
A
daptor
Locking Tabs
Back of
Microwave
4
5
6
11
B
ack of mircrowave
Knockout Plates:
Snip all 4 webs on
each knockout panel
and remove the metal
knockouts for rear
airflow. Please take care
to remove any sharp
edges created from
removing the knockout
plates.
8
9
10
with snips. (For some models)
7
Remove the knockout plates in the back of the unit
EN-18