Installation Guide

USE TOP CABINET TEMPLATE
F
OR PREPARATION OF TOP
CABINET
You ne
ed to drill holes for the top support screws,
a hole large enough for the power cord to fit
through, and a cutout large enough for the
exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• D
rill the holes, following the instructions on
the TOP CABINET TEMPLATE.
CAU
TION: Wear safety goggles when drilling
holes in the cabinet bottom.
I
nstallation Instructions
Blower Plate
Blower
Motor
Screw
Remove the
screw that holds the blower plate
to the microwave. Remove and save the screw
holding the blower motor to the microwave.
Back of
Microwave
End B
End A
Care
fully pull out the blower unit. The
wires will extend far enough to allow you
to adjust the blower unit.
1
A
DAPTING MICROWA VE
BLOWER FOR OUTSIDE
TOP
EXHAUST
Back of
Microwave
Back of
Microwave
Back of
Microwave
Roll the blower unit 90° so that fan blade
openings are facing out the top of the microwave.
Before Rotation
After Rotation
Back of
Microwave
Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Top
CAU
TION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly
secured.
4
Place the microwave in its upright position,
with the
top of the unit facing up.
C2.
C3.
EN-21
2
3