Installation Guide

3
MOUNT THE MICROWAVE
OVEN
2
Rotate
front of oven
up against cabinet
bottom.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be
completely tightened later.) Be sure to keep
power cord tight. Be careful not to pinch the
cord, especially when mounting flush to
bottom of cabinet.
NOTE
: When mounting the
microwave oven, thread
power cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1–3. Do not pinch
cord or lift oven by pulling
cord.
Lift microwave, tilt
it fo
rward, and hook
slots at back bottom
edge onto four
lower tabs of
mounting plate.
1
CHECK FOR PROPER
DAMPER OPERATION
Exhaust Adaptor
Blower Plate
Damper
Back of
Microwave
• Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
• You will need to make adjustments to assure proper
align
ment with your house exhaust duct after the
microwave is installed.
5
Secure blower unit to microwave with the screw
r
e
mov
ed in Step 1. Make sure the screw is tight.
Replace blower plate with the screw removed in
Ste
p 1. Make sure the screw is tight.
Back of
Microwave
6
7
Back of
Microwave
Guide
Adaptor
Attach the exhaust adaptor to the top of the
blower plate by sliding it into the guides
of the
blower
plate.
Locking Tab
Push in
securely until it is in the locking
tabs.
Take care to assure that the damper hinge
is
installed so that the
damper swings freely.
.
.
Installation Instructions
FOR E
ASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO
PEOPLE INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle or
heat shield during installation. Do not remove
the cardboard spacers between the heat
shield and door.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to
prevent cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom
shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
C3
.
C4
C5
ADAPTING MICROWA V
E
BLOWER
FOR
OUTSIDE
TOP EXHAUST
(cont.)
EN-22