Complete Owner's Guide

6
CONTROLS AND SETTINGS
CAUTION
Property Damage Hazard
Before starting dishwasher be sure that
the water is connected and turned on.
Failure to do so may cause damage
to the pump seal and result in water
leakage.
Wash Cycle Selections
Cycle times are approximate and will
vary with options selected. Hot water
is necessary to activate dishwasher
detergent and melt fatty food soils. An
automatic sensor will check the incoming
water temperature and, if it is not hot
enough, the cycle will be lengthened
for automatic water heating in the main
wash and final rinse of all cycles. This
happens even when HIGH TEMP WASH
option has not be selected. When HIGH
TEMP WASH is selected, an even higher
temperature will be reached to handle
heavier soil loads.
Starting a Cycle
Option Selections

NOTE
Your dishwasher uses a DishSense
TM
Technology to understand how much
food is on the dishes and then adjusts
the cycle accordingly.
Recommended Cycle for typical
use:
The Normal cycle with its factory default
options of normal temperature and
heated dry together provide the best all
around performance. This cycle selection
is recommended for everyday use and
is suitable for a large range of both dish
load sizes and food quantities remaining
on those dishes.
2
Wash Temp
High
Select by pressing the HIGH pad.
The dishwasher heats water in
the main wash to approximately
140°F (60°C) and increases the
temperature higher in the final rinse
to help with the drying stage.
2 3 4 5 6 71
1
When the cycle and options have
been selected, the LEDs over the
cycle and options selected will
illuminate. The status window will
display the cycle time and then
displays “Press START”.
To start the cycle, press START/
CANCEL pad and close the door
immediately.
The status window displays “Close”
after the START/CANCEL pad is
pressed.
A tone will sound indicating the
cycle has successfully started after
the door is closed.
My Favorite Cycle
The MY FAVORITE CYCLE option
allows you to program your
preferred cycle and options into
one button. Once Programmed,
simply press the MY FAVORITE
CYCLE button followed by the
START/CANCEL pad to select the
programmed cycle and options.
To Program the MY FAVORITE
CYCLE button:
1. Select your preferred cycle
and options
2. Hold the MY FAVORITE CYCLE
button for 3 seconds.
The LED over the MY FAVORITE
CYCLE turns on indicating the MY
FAVORITE CYCLE option has been
programmed. To change the MY
FAVORITE CYCLE option simply
repeat steps one and two above.