Complete Owner's Guide

7
CONTROLS AND SETTINGS
This helps dishwasher detergent
remove food grease and soil from
dishes more eectively and aids
in drying performance by adding
additional rinse aid and increasing
the water temperature.
Sanitize
Select SANITIZE option, by
pressing SANITIZE pad to sanitize
your dishes and glassware. When
selected, the light illuminates
and remains on after the cycle
has completed. The water
temperature in the final rinse rises
to 155°F (68°C) and maintains
that temperature for 9 minutes.
This option is available in HEAVY
and NORMAL wash cycles. Only
these sanitization cycles have
been designed to meet NSF
requirements.
The cycle time is extended until
the proper water temperature is
reached. Washing action continues
during the water heating delay. For
best results, the incoming water
temperature should be at least
120°F (49°C).
The sanitize criteria may not be
satisfied if there is an interruption
of the cycle, power failure or if the
incoming water temperature is
below 120°F (49°C).
Sanitize pad flashes at the end of
the cycle if the NSF requirements
for sanitization are not reached.
Press the SANITIZE pad to turn o
the SANITIZE option. The SANITIZE
light will turn o.
3
Air Dry
The AIR DRY option uses reduced
temperature in the final rinse. While
saving energy and time, you may
have items in your dish load that will
not be completely dry at the end
of the cycle. Deselecting AIR DRY
option in combination with rinse aid
will enhance drying performance.
AIR DRY option is not available on
all cycles.
Vented Drying Option on 30 Min
Wash
Vented drying will heavily improve
drying performance. This is a default
setting on Heavy, Normal, China
Crystal and Energy Saver, and
an option on 30 min Wash cycle.
Deselect Air Dry to select Vented
Drying. (Vented drying is activated
when Air Dry LED is OFF.)
• Air Dry led on » Fan OFF
• Air Dry led o » Fan ON
(vented drying option
selected).
This option turns the fan on during
the dry cycle to support drying
performance and extends the cycle
30 minutes.
4
Wash Pressure
The programmed cycles default to
the “surge” pressure option which
varies the pressure optimally for
the cycle’s intended normal use.
If, for some special circumstance,
either a very low “spray” or very
high “scour” pressure is desired that
may be selected. Due to wash cycle
optimization, some pressure options
are not selectable in all wash cycles.
Spray
Press SPRAY pad to select this
option. This varies the pressure
optimally for the cycle’s intended
normal use.
Scour
Press SCOUR pad to select this
option. This provides a very high
“scour” pressure. Due to wash cycle
optimization, this option is not
selectable in all wash cycles.
SPRAY and SCOUR can not both be
selected to run together.
5
Status Window
The Status Window indicates the
number of delay start hours, the
number of minutes left in a cycle,
the level of rinse aid dosage,
and the CLOSE and START cycle
prompts.
6
Delay Time
The DELAY TIME option allows you
to automatically delay starting your
dishwasher from 1-24 hours.