Complete Owner's Guide
Table Of Contents
- Introduction
- Important Safety Information
- Features
- Installation
- Door Removal
- Door Handle Installation
- Water Supply Connection
- Controls and Settings
- Automatic Ice and Water Dispenser
- Storage Features
- Storing Food and Saving Energy
- Normal Operating Sounds
- Filter Replacement
- Care and Cleaning
- Troubleshooting
- Limited Warranty
15
DOOR HANDLE INSTALLATION
Door Handle Mounting Instructions for Frigidaire Professional®
Mounting Refrigerator Handles
NOTE
When tightening the Allen set screws, it is imperative that force be applied to the
longer arm of the Allen wrench supplied in the handle packaging.
NOTE
All set screws should be tightened so the screw is below the surface of the handle.
The handles should be drawn tight to doors with no gaps. Opening the opposite
door while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this hap-
pens, tighten the set screws on the handles.
1. Remove handles from carton
and any other protective
packaging.
2. Position fresh food handle end
over upper and lower pre-
installed shoulder bolts (A)
that are fastened into door,
ensuring the holes for the set
screws are facing towards the
opposite door.
3. While holding handle firmly
against door, fasten further
most upper and further most
lower Allen set screws (B) with
supplied Allen wrench.
4. Repeat steps 2 and 3 to install
opposite handle. Ensure the
holes for the set screws are
facing towards the first door.
5. Firmly tighten the inside Allen
set screws.
CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.