Installation Instructions

Attach the exhaust adaptor to the rear of the
oven by slidin g it into th e guides at the top
cen ter of the back of the oven.
AFTER: Fan Blade
Openings Facing Back
Place the blower un it back into the open in g.
Replace th e blower plate in the same position
as before with the screw. Make sure the screw
is tight.
Roll th e blower un it 90° so th at fan blade
openin gs are facing out th e back of th e
microwave.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
B5.
Rotate blower un it counterclockwise 180°.
Before Rotation After Rotation
Gently remove the wires from the grooves.
Reroute th e wires through grooves on other side
of the blower unit.
Before Rerouting After Rerouting
Wires Routed Through Right Side
Wires Routed Through Left Side
Back of
M icrow ave
Back of
M icrow ave
Blow er Plate
Blow er Motor
Screw
Secure the blower unit to th e microwave with
the original screw.
Before Rolling After Rolling
Back of
M icrow ave
End A
End B
Back of
M icrow ave
Back of
M icrow ave
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
NOTE: The blower unit exhaust
openings should match exhaust
openings on rear of microwave oven.
Installation Instructions
Push in securely un til it is in the lower locking
tabs. Take care to assure th at the damper hinge
is in stalled so that it is at th e top an d th at the
damper swings freely.
Guide
Guide
Adaptor
Locking Tabs
Back of
M icrow ave
Back of
M icrow ave
Roll th e blower un it 90°
Back of
M icrow ave
3
4
5
6
7
8
9
10
Before Rotation After Rotation
EN-18