FILTERED ICE KIT: TTFLTRICEKIT Models: INSTRUCTION SHEET FPFU19F8WF FPRU19F8WF EI33AF80WS EI33AR80WS Kit Contents: B A (1x) 218976831 1/4” Green water line, 16 feet C D C (2x) 240396805 (2x) 240396804 1/4” Green water line 1/8” Wiring harness strain relief strain relief (2x) F E (1x) A19408101 Wiring Harness 19 Feet (2x) 305346-00 Wiring Harness support clips ORIGINAL CONFIGURATION Rear View Refrigerator Rear View Freezer © 2020 Electrolux Home Products, Inc.
FILTERED ICE KIT: TTFLTRICEKIT Models: INSTRUCTION SHEET FPFU19F8WF FPRU19F8WF EI33AF80WS EI33AR80WS NOTE: This kit is designed to provide filtered water to the freezer ice maker when a single-door freezer is installed next to a single-door refrigerator. NOTE: An authorized service technician is recommended to install the filtered ice kit. NOTE: Disconnect electrical power prior to servicing this product.
Models: INSTRUCTION SHEET FPFU19F8WF FPRU19F8WF EI33AF80WS EI33AR80WS Refrigerator Connections 1. Feed the green water line (A) and wiring harness (E) through the opening of the refrigerator access cover. 2. Push the green water line into the green port of the water valve. 3. Connect the wiring harness (E), to the connector on the refrigerator. 4. Locate wiring harness support clip at top of refrigerator machine compartment (F), and insert wiring harness to secure.
Models: INSTRUCTION SHEET FPFU19F8WF FPRU19F8WF EI33AF80WS EI33AR80WS Freezer Connections NOTE: The freezer water valve and the connecting harness are not used when this kit is installed for filtered water provided by the paired refrigerator. 1. Disconnect and remove the 10” green water line by pushing upward on the port tab, while pulling out the line. 4. Connect the harness (E) from the refrigerator to the connector for the freezer.
Models: INSTRUCTION SHEET FPFU19F8WF FPRU19F8WF EI33AF80WS EI33AR80WS Water Line Final Connections 1. Fasten the strain reliefs for green water line (B) and for wiring harness on each unit. (C) 2. Attach the two adhesive support clips (F) and insert the green water line and harness. 3. Loop the water line and wire harness in the center of the two units. (F) (F) (F) (B) (C) 4. Connect and turn on water supply. 5. Purge air from water lines by dispensing water from refrigerator water dispenser.