2-IN-1 EVAPORATIVE COOLER AND FAN EC100WF Owner’s Manual Manual v1.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Register Your Product Online ....................................................................... 3 Safety Information & Warnings ................................................................... 4 Parts List ................................................................................................................6 Features .................................................................................................................
REGISTER YOUR PRODUCT ONLINE Register Your Frigidaire Product Online Today! Take advantage of all the benefits product registration has to offer: Service and Support Diagnose troubleshooting and service issues faster and more accurately Recall Notifications Stay up to date on safety notices, system updates, and recall notifications Special Promotions Opt-in for NewAir promotions and offers Registering your product information online is safe & secure and takes less than 2 minutes to complete: newair.
SAFETY INFORMATION & WARNINGS In order to use the product safely and to avoid any danger caused by incorrect operation, please pay close attention to the warnings and instructions in this manual. • • • • • • • • • Please read all instructions carefully before using this product. Before use, please check whether the operating voltage matches the voltage on the label of the unit. Cleaning and maintenance should never be done by children without supervision.
• • • • • • Turn off the power and remove the power cord (be sure to unplug the power cord when cleaning the body, or else it may cause electric shock and fire or other personal injury). When cleaning, use ordinary detergent and a soft brush. Do not use chemical agents. Do not use corrosive detergent or solvent. Do not clean the appliance with excessive amounts of liquid cleaners, as it may cause electrical shock.
PARTS LIST 1. Casters 2. Water tank 3. Horizontal blades 4. 5. 6. 7. Vertical blades Outlet grille Front shell LED indicators 8. Control panel 9. Rear shell 10. Remote control storage 11. Rear dust filter 12. Cooling pad 13. Power cord 14.
FEATURES 1. 2. 3. 4. 5. 6. 7. 8. 9. 10.
PRODUCT INSTALLATION AND USAGE Remove the product from the packaging and review the instructions along with any other included accessories. The unit can be used immediately after being removed and unpacked.
TIMER While the unit is on, press this button to enable the auto-shutoff feature. Keep pressing the button to cycle through the timer options, 1, 2, 4 or 8 hours. Once the selected time has completed, the unit will shut off. EVAPORATIVE COOLING While the unit is on, press this button to enable evaporative cooling. Please note that in order for evaporative cooling to work, the water tank must be filled in between the min and max fill lines.
Nature mode: The unit operates normally, except fan speed automatically cycles between the three settings; low, medium and high. This mode is meant to replicate a shifting natural breeze. Sleep mode: The unit will run for 30 minutes at whatever fan speed was set by the user before changing to sleep mode, then gradually decrease fan speed. If set at high speed, the unit will stay at high speed for 30 minutes, then medium for 30 minutes, then low until the unit is manually shut off.
USE OF REMOTE CONTROL 1. First, open the battery cover on the back of the remote control and install a 3V CR2032 battery. 2. When using the remote, point it toward the control panel, which has a receiver on the far right of the panel. 3. When the battery is low, please replace it immediately. Dispose of batteries properly and keep them away from children.
CLEANING AND MAINTENANCE 1. 2. 3. Unplug the unit before cleaning and maintenance. Remove the dust filter and cooling pad for cleaning. Please clean both parts at least once every two months, as dust buildup can affect the efficiency of the unit. To clean the dust filter, use a mild detergent and a soft brush, or vacuum any dust buildup. To clean the cooling pad, soak it in mild detergent for a few minutes, then clean and dry it. You can also use a vacuum to clean the cooling pad as long as it is dry.
OUTER SURFACE CLEANING 1. 2. Unplug the unit. Clean the surface of the unit and wipe it off with a damp cloth. Do not rinse the unit directly with water, or use corrosive detergents. MAINTENANCE 1. 2. 3. When the unit is not going to be used for a long time, unplug the power, pack the unit for storage, and prevent dust buildup by packing the unit into its original box, or covering it with a sheet. Before storing, ensure that the dust filter and cooling pad are completely dry.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
