Dishwasher Use & Care Manual

5
Getting Started
1. Load dishwasher
2. Add detergent
3. Add rinse aid
4. Select desired CYCLE. The indicator light above the
pad will glow when selected.
5. Select desired OPTIONS. The indicator light above
the pad will glow when selected.
6. Run hot water faucet nearest dishwasher until water
is hot. Turn water off.
7. To start, press START/CANCEL pad.
8. Close door to latch.
NOTE
The dishwasher is programmed to remember your last
cycle so you do not have to reset each time. To start the
dishwasher using the same cycle and options selected on
the previous wash, just press the START/CANCEL pad.
Wash Cycle Selections
Cycle times are approximate and will vary with options
selected. Hot water is necessary to activate dishwasher
detergent and melt fatty food soils. An automatic sensor
will check the incoming water temperature and, if it is
not hot enough, the timer will be delayed for automatic
water heating in the main wash of all cycles. This
happens even when HI-TEMP WASH option has not been
selected. When HI-TEMP WASH is selected, an even
higher temperature will be guaranteed to handle heavier
soil loads.
OPERATING INSTRUCTIONS
1-24 hrs
START
cancel
air
dry
hi temp
was h
delay
startsanitize
top
rack
rinse
only
washing
drying
clean
sanitized
hold to lock
add rinse aid
heavy
wash
normal
was h
air
dry
hi temp
wash
delay
startsanitize
top
rack
rinse
only
2
4
6
START
cancel
washing
drying
clean
sanitized
hold to lock
normal
wash
heavy
wash
washing
drying
clean
sanitized
1-24 hrs
sanitize
delay
start
hi temp
wash
heavy
wash
light
wash
top
rack
rinse
only
normal
wash
air
dry
START
cancel
add rinse aid hold to lock
FGBD2431
FGBD2432
Press the CIRCLE to activate
FGBD2451