USE & CARE MANUAL READ AND SAVE THESE INSTRUCTIONS ELECTRONIC CONTROL AIR CONDITIONER P/N 220211A243
ROOM AIR CONDITIONER WARRANTY Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this warranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this warranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer.
Product Registration Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Model No. Serial No. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Contents NOTE: This Owner’s Guide provides specific operating instructions for your model.
Important Safety Instructions Read all instructions before using this air conditioner. For Your Safety Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Read product labels for flammability and other warnings. The power supply cord with this air conditioner contains a current detection device designed to reduce the risk of fire. Please refer to the section ‘Operation of Current Device’ for details.
Air Conditioner Features ELECTRONIC CONTROL OPERATING INSTRUCTIONS Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the unit control alone or with the remote. ADJUSTS TEMPERATURE OR TIME SET TEMP.
Air Conditioner Features (continued) TO CHANGE TEMPERATURE SETTING: YOU WILL SEE: 72 Note: Tap or hold either up( ) or down( ) button until the desired temperature is seen on the display. This temperature will be automatically maintained anywhere between 62˚F (17˚C) and 86˚F (30˚C). If you want the display to read the actual room temperature. See “To Operate on Fan Only” section on Page 7. DO THIS: . PRESS TO RAISE .
Air Conditioner Features (continued) TO USE DRY MODE: YOU WILL SEE: LIGHT On 62 DO THIS: . PRESS MODE BUTTON Note: Use this mode when the room is already cool below 65oF (18oC) but the room is slightly humid. . CHOOSE DRY TO USE AUTO COOL: YOU WILL SEE 72 LIGHT On DO THIS: . PRESS MODE BUTTON Note: In this mode when the room temperature is reached the compressor will shut off and after a few minutes the fan will switch to the lowest setting, (if a higher setting has been originally selected).
Air Conditioner Features (continued) TO USE THE ENERGY SAVER FEATURE: YOU WILL SEE: LIGHT On 72 Note: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and cooling stars. DO THIS: . . PRESS ENERGY SAVER BUTTON TIMER: DELAY STOP / START FEATURE YOU WILL SEE: TIMER SETTING LIGHT On 0.5 8.
Air Conditioner Features (continued) CHECK FILTER FEATURE: YOU WILL SEE: LIGHT On DO THIS: AFTER CLEANING PRESS CHECK FILTER BUTTON . . Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the “Check Filter” button and the light will go off. CLEAN AIR FEATURE YOU WILL SEE: (on some models): LIGHT On DO THIS: .
Air Conditioner Features (continued) FAULT CODES: WARNING CODES: If the display reads “AS” or “ED”, a sensor has failed. Contact your Authorized Frigidaire Service Center. In the fan mode if “LO” or “HI” is displayed, this means the room temperature is outside the unit set points of 99oF/37oC (HI) or 32oF/0oC (LO). . . YOU WILL SEE˖ TO TURN UNIT OFF: . .
Air Conditioner Features (continued) ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with. • The “Cool “ circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time.
Care and Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards. Air Filter Cleaning The air filter should be checked at least once a month to see if cleaning is necessary. Trapped particles in the filter can build up and cause an accumulation of frost on the cooling coils. • Push the vent handle to the Vent Closed position (where applicable). • Open the front panel.
Avoid Service Checklist Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workman-ship or materials in this appliance. OCCURRENCE SOLUTION Air conditioner will not operate. Wall plug disconnected. Push plug firmly into wall outlet. Plug Current Device Tripped. Press the RESET button. House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker.
