Installation guide

IMPORTANT
Do not lift the oven by the door handle.
3. Insert the oven into the cabinet opening. Slide oven
inward leaving 11/2"(3.8 cm) clearance between the
oven and front of cabinet (see Figure 6). Pullthe armored
cable through the hole for it in the cabinet and toward
the junction box while moving the appliance inward.
" lY2" (3.8 cm)
clearance
between unit
Figure 6
4. Pushthe oven in and against the cabinet; the oven side
bracket will clip into the mounting brackets installed into
the side of cabinet.
To pull out the oven for servicing you must use the two
tools supplied with the oven. Insert one tool into hole in
each side of oven frame. Holes are visible when door is
opened. After inserting tools pull the oven towards you
(see Figure 7).
5. Bottom Trim Installation:
Placethe top of the bottom trim over the side trim tabs
on each side of the oven below the oven door and fix it
using the 2 screws supplied in the mounting holes located
on each side trim below the oven frame (see Figure 8).
f
Oven
side -.
trim
ov)
Screws
Mounting
i racket installed
in cabinet
Cabinet
Right
Side
Tool
_supplied I
Mounting
bracket
released
I J !B
Oven removed
from the cabinet
Hole where to
insert the tool
Figure 7
--Bottom Trim
Figure 8
7