Installation guide

6. For typical under counter installation of an electric built-in oven see Figure below.
Only certain cooktop models may be installed over certain
built-in electric oven models. Approved cooktops and built-
in ovens are listed by the MFG ID number and product
code (see the insert sheet included in the literature pack-
age and cooktop installation instructions for dimensions).
To reduce the risk of
personal injury and
tipping of the wall
oven, the wall oven
must be secured to
the cabinet (s) by
mounting brackets,
Approx. 3
(7.5 cm)
Cabinet side filler panels are
necessaryto isolate the unit
from adjoining cabinets. Cabinet
side filler height should allow for
installation of approved cooktop
models
36" Min.
(91.4 cm) Min.
208/240 Volt junction box
for built-in oven.
Use 3/4" (1.9 cm) plywood, installed on two
runners, flush with toe plate. Basemust be
capable of supporting 150 pounds (68 kg)
for 27" models and 200 pounds (90 kg) for
30" models.
Cut an opening in wood base minimum 9" x 9"
(23 X 23 cm), 2" (5 cm) from left side filler
panel, to route armoured cable to junction box.
4 1/2" (11.5 cm) Max.*
* If no cooktop is installed directly over
the oven unit, 5" (12.7 cm) maximum
is allowed above the floor.
27" (68.6 cm) 247/8" (63.2 cm) Min. 23Y2" (59.7 cm) Min. 27¼" (69.2 cm) Min.
Wall Oven 25¼" (64.1 cm) Max. 28s/8'' (72.7 cm) Max.
30" (76.2 cm) 281/2" (72.4 cm) Min. 27¼" (69.2 cm) Min.
Wall Oven 29" (73.7 cm) Max. 23Y2" (59.7 cm) Min. 28s/8'' (72.7 cm) Max.
Figure 9=TYPICAL UNDER COUNTER INSTALLATION OF A SINGLE ELECTRICBUILT-IN OVEN
WITH AN ELECTRICCOOKTOP MOUNTED ABOVE
8