Installation guide

Installation Instructions

MOUNT THE MICROWAVE

OVEN (cont.)

[] Insert 2 self-aligning screws

through outer top cabinet

holes. Turn two full turns on

each screw.

[]Tighten center

screw completely.

[] Tighten the outer two screws to the top of the

microwave oven. (While tightening screws, hold

the microwave oven in place against the wall and

the top cabinet.)

[] Install grease filters. See the Owner's Manual

packed with the microwave.

_-_ INSTALLING OR CHANGE

THE CHARCOAL FILTER

NOTE: The charcoal filter is factory installed in

recirculating models. Follow these steps to replace a

filter or to install a filter after converting a vented

model to recirculating operation.

[] Remove screws on top of grille using a

#1 Phillips screwdriver'.

[] Open the door.

[] Remove the grille.

Pull the grille straight off.

Charcoal

Filter

[] Install the charcoal filter: Insert filter upper

in the unit and then pull down filter. When

properly installed, the wire mesh of the filter

should be visible fl'om the fl'ont.

Insert

[] Replace the grille and the screws.

[] Close the door.