Installation guide

Installation Instructions

MOUNT THE MICROWAVE

OVEN (cont.)

[]Insert 2 self-aligning screws

through outer top cabinet

holes. Turn two full turns on

each screw.

[] Tighten center

screw completely.

[] Tighten the outer two screws to the top of the

microwave oven. (While tightening screws, hold

the microwave oven in place against the wall and

the top cabinet.)

_ Install grease filters. See the Owner's Manual

packed with the microwave.

INSTALLING THE

CHARCOAL FILTER

NOTE: The charcoal filter is factory installed in

recirculating models. Follow these steps to replace a

filter or to install a filter after converting a vented

model to recirculating operation.

[]Remove screws on fi'ont of grille using a

#1 Phillips screwdriver.

_Open the door.

[]Remove the grille.

Pull the grille straight off.

Charcoal

Filter

[] hrstall the charcoal filter. When properly installed,

the wire mesh of the filter should be visible from

the fl'ont.

[Replace the grille and the screws.

[]Close the door.

Insertmesh-sideup