Installation guide

Installation Instructions

OUTSIDE TOP EXHAUST (Vertical Duct)

INSTALLATION OVERVIEW

AI. Attach Motmtirlg Plate to Wall

A2. Prepare Top Cabinet

A3. Check Damper Operation "[

A4. MouIrt Microwave Oven

A5. Adjust Exhaust Adaptor

A6. Connect Ductwork

I-_ ATTACH THE MOUNTING

PLATE TO THE WALL

Attach the plate to the wall using toggle bolts.

At least one wood screw must be used to attach

the plate to a wall stud.

[]Remove the fl'om the bolts.toggle wings

[]Insert the bolts into the mounting plate

through the holes designated to go into drywall

and reattach the toggle wings to 3/4" (19 ram) onto

each bolt.

To use toggle bolts:

Mounting

Plate,

Spacingfor Toggles

MoreThanWall

÷l_.j_--Thickness

iToggleWings

BoltEnd

[]Place the nlounting plate against the wall and

insert the toggle wings into the holes in the wall

to mount the plate.

NOTE: Before tightening toggle bolts and wood

screw, make sure the tabs on the mounting plate

touch the bottom of the cabinet when pushed

flush against the wall and that the plate is properly

centered under the cabinet.

CAUTION: Be careful to avoid pinching fingers

between the back of the mounting plate and the wall.

[]Tighten all bolts. Pull the plate away from the wall

to hel t) tighten the bolts.