Installation guide

Installation Instructions

OUTSIDE BACK EXHAUST (Horizontal Duct)

INSTALLATION OVERVIEW

B1. Prepare Rear Wall

B2. Remove Exhaust Adaptor

Ba. Attach Mounting Plate to Wall

B4. Prepare Top Cabinet

B5. Adjust Blower

B6. Mount tile Microwave Oven

IMPORTANT NOTES:

• Make sure tile screws for tile

blower motor and blower plate

are securely tightened when

they are reinstalled. This will

hel t) to prevent excessive

vibration.

• Make sure tile motor wiring has

been properly routed and secured,

and that tile wires are not pinched.

[-_ PREPARING THE REAR WALL

FOR OUTSIDE BACK EXHAUST

You need to cut an opening in tile rear wall for

outside exhaust.

• Read tile instructions on tile REAR

WALL TEMPLATE.

• Tape it to tile rear wall, lining up with tile

holes previously drilled for holes A and B

in tile wall plate.

• Cut tile opening, following tile instructions of tile

REAR WALL TEMPLATE.

I-_ REMOVE EXHAUST ADAPTOR

This microwave oven is shipped assembled for top

exhaust. You will need tile exhaust adaptor for

installation in tile rear wall opening. To remove

tile exhaust adaptor fl'om tile microwave oven:

[]Remove tape securing damper.

[] Raise damper flap. [] Slip tile damper

B, r,, _ out of tile track

lower\Hate _ on tile blower

' _ _ fi'ame by pressh-lg

[]Remove and save tile screw that holds tile blower

plate to tile microwave. Lift off tile blower plate.

Blower Plate

I o

_ _ _ Backof

Microwave