Installation guide

Installation Instructions

PLACEMENT OF THE MOUNTING PLATE

I-_ REMOVING THE MICROWAVE

OVEN FROM THE CARTON/

REMOVING THE MOUNTING

PLATE

[]Remove the installation instructions, filters, glass

tray and the small hardware bag. Do not remove

the Styrofoam protecting the fl'ont of the oven.

[]Fold back all 4 carton flaps fully against carton

sides. Then carefully roll the oven and carton over

onto the top side. The oven should be resting in

the Styrofoam.

[Pull the carton up and off the oven.

[]Remove and properly discard plastic bags.

Screws----__

Mounting

Plate

[]Remove the screws from the mounting plate.

This plate will be used as the rear wall template

and for mounting. Reinstall the screws into the

holes where they were removed.

I-_ FINDING THE WALL STUDS

]Find the studs, using one of the following

methods:

A. Stud finder - a magnetic device which

locates nails.

B. Use a hammer to tap lightly across the

mounting surface to find a solid sound.

This will indicate a stud location.

[] After locating the stud(s), find the center by

probing the wall with a small nail to find the edges

of the stud. Then place a mark halfway between

the edges. The center of any adjacent studs should

be 16" (40.6 cm) or 24" (61 cm) fi'oln this mark.

[]Draw a line down the center of the studs.

THE MICROWAVE MUST BE CONNECTED TO

AT LEAST ONE WALL STUD.