Installation guide

Installation Instructions
C
lose the microwave door. Plug in microwave
oven or reconnect power.
Reinstall the vent by sliding the bottom of the
vent into place. Push the vent top into position
and slide right into place. Replace the two vent
mounting screws located on top of the microwave
using a #1 Phillips screwdriver.
IMPORTANT: Remove the cardhoard spacers between
heat shield and door.
Press the bottom of charcoal filter to place it
into the correct position.
Remove the PureAir Filter from the packaging
1
and shake filter to remove excess carbon.
®
Use a Phillips head screwdriver to unscrew the
PureAir Filter access door.
2
®
Open the filter access door.
3
Quick
Start
Remove the existing PureAir Filter(if installed)
4
by pulling forward out from the unit.
®
EN-2
3
For models with the recirculation filter access door
follow these steps to replace or install a PureAir
ilter.
®
F
M
i
c
r
o
w
a
v
e
,
5
6
7