FRIGIDAIRE _7!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i!i! 7_7_7_7i!_i_i_i_i_i_i_iiiiiiiii_i_7i_7i_1i7_7_!_ _'_i_17_!i_7_7_i_7117_i_i! , _!i!{ii!i Normal Air CondJtionei www,frigidaire.
This USE & CARE MANUAL instructed in this may occur. Common The power supply device sense cord this air conditioner detection of fire. In the event designed and caution instructions instructions must be practiced for your are not meant when installing, model. to cover operating, Use the room every possible air conditioner condition and maintaining only as and situation that any appliance. from the risk 'Operation supply be repaired.
CAUTION. I Avoid Injury o Provide units o occasional ventilation during use. Do not direct or damage to the unit or other airflow at fireplaces or other heat related property sources as this could cause flare ups or make run excessively. Do not climb Do not hang on or place objects on outdoor objects off the unit. part of the unit. Do not place containers with liquids on the unit.
Product Registration Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Register Your Product The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company. Normal Sounds H!gh pitched Chatter Today's high efficiency compressors may have a high pitched chatter during the cooling cycle.
Air Conditioner ELECTRONIC Features CONTROL Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol for the functions you desire. The unit can be controlled by the touch pad alone or with the remote.
Operating Instructions TO CHANGE TEMPERATURE SETTING: YOU WILL SEE: tamp/timer auto m hi auto m hi DO THIS: mad reed lo lo PRESS A TO RAISE heat [] cool heat [] cool energy saver energy saver V TO LOWER Zanonly fan only % Note: Tap or hold either up ( A ) or down ( V ) button until the desired temperature is seen on the display. This temperature will be automatically maintained anywhere between 16 °C (60 °F) and 32 °C (90 °F) for cooling mode.
Operating Instructions (continued) TO USE THE ENERGY SAVER FEATURE; YOU WILL SEE: temp/timer temp/dmer auto auto [] hi [] hi DO THIS; reed med lo PRESS heat cool heat COOl MODE BUTTON energy saver [] energy save, fanon_ ._______------ CHOOSE ENERGY SAVER Note: In this mode, the fan will continue to run for 1 minute after the compressor shuts off.
YOU WILL SEE; temp/timer DO THIS: PRESS FILTER RESET BUTTON Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) Will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off. REMOTE SENSING FEATURE (on some models): LIGHT pulsing ( On & Off intermittently ). o temp/timer \, / }mA m_l
Operating Instructions (continued) FAULT CODES: temp/timer temp/timer auto temp/timer auto m hi auto [] hi med [] hi med lo med lo lo m heat m heat COOl m heat cool energy cool remote saver energy senstng ian on_ remote _ensmg saver energy If the display reads "HS", a sensor has failed. Contact your Authorized Frigidaire Service Center. TO CHANGE TEMPERATURE rem£_e saver sensmg fan only fan on_ If the display reads "AS", a sensor has failed.
Operating Instructions (continued) 4-Way Air Directional Louvers The 4-Way air directional louvers allow you to direct the air flow Up or Down and Left or Right throughout the room as needed. To adjust the air directional louvers side-to-side, use the center handle as you move it side-to-side. (4-WAY) Care and Cleaning Clean your air conditioner occasionally to keep it looking new.
Before callingforservice, reviewthislist.It maysaveyoutimeandexpense. Thislistincludes common occurrences thatarenot theresultofdefective workmanship ormaterials inthisappliance. OCCURRENCE SOLUTION Air conditioner will not operate. Wall plug disconnected. Push plug firmly into wall outlet. Plug Current Device Tripped. Press the RESET button. House fuse blown or circuit breaker tripped, Replace fuse with time delay type or reset circuit breaker, Control is OFF.
Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
