Complete Owner's Guide

25
CHANGING THE FILTER
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system. Systems
certiedforcystreductionmaybeusedon
disinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• Rated Capacity - 125 gallons/473 liters for
PureSource Ultra II
TM
iceandwaterlter
• Ratedserviceow-.65gallonsperminute
• Operating Temp: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
squareinch
• Recommended Minimum Operating
Pressure:30poundspersquareinch
The PureSource Ultra II
TM
iceandwaterltersystemis
testedandcertiedtoNSF/ANSI
Standards 42, 53 and 401 for the
reductionofclaimsspeciedon
the performance data sheet.
More about your Advanced
Water Filter
To replace your PureSource Ultra II
TM
water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
small amounts of water released during the
lterreplacement.
1 Turn Off the ice maker power switch.
 2 Removetheoldlterbyrotatingitcounter-
clockwise (to the left) 90 degrees to release it.
 3 Slidetheoldltercartridgestraightoutof
the housing and discard it.
 4 Unpackagethenewltercartridge.Slideit
intothelterhousingasfarasitwillgowith
the grip end horizontal.
 5 Pushlightlyinwardonthelterwhilerotating
itclockwise(totheright).Thelterwillthen
pull itself inward as it is rotated. Rotate the
lter90degreesuntilitstopsandthegrip
end is vertical. You may be able to feel a very
lightclickasthelterlocksintoplace.
6 Press a drinking glass against the water
dispenser while checking for any leaks at
thelterhousing.Anyspurtsandsputters
that occur as the system purges air out of
the dispenser system are normal.
7 Continue dispensing water for 3-4 minutes
oruntil1.5gallonsofwaterhasowed
through the system. You will likely need to
emptyandrellyourglassseveraltimes.
8 Turn On the ice maker.
9 Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes from
Red to Green, the status has been reset.