IMPORTANT INSTRUCTIONS & OPERATING MANUAL Dallas Floor Standing Fireplace Item No: DSF-1/0302 Read these instructions carefully before attempting to assemble, install, operate or maintain the product. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and / or property damage. Retain instructions for future reference.
GENERAL SAFETY INFORMATION When using this fireplace, basic precautions should always be taken to reduce the risk of fire, electric shock and injury to persons, including the following: CAUTION – Due to the high temperature, keep electrical cords, drapery and other furnishings at least 3 feet from the front, side and rear of the fireplace. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22.
23. Faulty wall outlet connections may cause the wall outlet to overheat. Be sure that the fireplace plug properly fits into the outlet before each use. During use, make sure the fireplace plug does not overheat. If necessary, have a qualified electrician check and / or replace the wall outlet. 24. Do not place the fireplace near a bed for objects such as pillows or blankets can fall off the bed and be ignited by the fireplace. 25. Never clean this fireplace while it is plugged in.
Helpful Advice Before Installation • • • • Please retain all packaging until all the parts and other package contents are accounted for. It is recommended to place your fireplace near an existing wall outlet for ease of electric connection. Store your fireplace in a dry, safe and dust-free place while drilling during fireplace installation. Do not attempt to wire new outlets or circuits.
Troubleshooting Problem Possible Solution · Check if the unit is plugged in the power outlet. · Check if the unit is in Standby mode. If so, turn the unit ON. · Check if the heat is turned OFF. · Check for safety cut-off operation. Unit does not work / does not heat · Check if the unit is plugged in the power outlet. · Check if the unit is in Standby mode. Turn the unit ON. No flame effect Replacing the Light Bulb • • This fireplace consists of 2 bulbs (E-12, 40W) that illuminate a flame effect.
Cleaning & Maintenance • • • Disconnect from the power supply before attempting any maintenance or cleaning in order to reduce the risk of fire, electric shock to persons or damage to property. Warning - Always disconnect from the power supply before cleaning fireplace. For general cleaning, use a soft, clean duster. Never use abrasive cleaners. The glass viewing screen should be cleaned thoroughly with a soft cloth. Do NOT use proprietary glass cleaners.