Installation Instructions Cooktop L_Electrolux
IMPORTANT SAFETYINSTRUCTIONS NiNllNmiNiHNNHNnaNNilN SafetyPrecautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
Safety SAFETYPRECAUTIONS
Safety ililili!iii! ii_i_iiiiii _!iiiiiiiiiiii iiiiiiii!iii!i ili!ii!iiiiii!i !!ili!!!iii! iii_iiii!i_iii _iiii!iiiiiiiili_ i!!iiiiiiii!ii iiii!i!iiiiiiiii !iii!i!!!!_ill iiiiiii,_!iiiilili iiiii!]iiiiii i!iiiii!!iii_ iiiiiiiiiii!i_ iiiii!ii!!iiiiiiiiiiiiiiii_iiiiiii!_iiii!i!i !_iii!ii_iil i_iiii!ii_ :Y:2:2P_S
Finding Information READANDSAVETHESEINSTRUCTIONS mmmmmmmmmmmmmmmmmmmmmm )) Read all instructions before installing the cooktop. For your safety, please read and observe all safety instructions. you anticipate all installation connections. QUESTIONS? mmmmmumtmBmmmmmmtmmmmm For toll-free telephone support in the U.S. and Canada: 1-877- 4ELECTROLUX (1-877-435-3287) For online support and Internet product information: www.electroluxusa.com _2005 Electrolux Home Products,Inc.
Finding Information TABLEOF CONTENTS mmmmmmmmmmmmmmmmnmmmmm Safety................................................................... 2 OeffniUons .......................................................... 2 Important SafetyInstructions 2 SafetyPrecautions ............................................. 3 .............................. FindingInformation........................................... 5 PleaseReadAndSaveThisGuide...................5 Questions? ....................................................
Preparing for Installation ii!iiii!!ii!ii; VERIFYPACKAGECONTENTS • • • • • • • • • • • • • • • • • • Use & Care Manual • Cleaning Kit • Hold Down Bracket Kit • Grill Drip Pan (E46GC67ESS only) • Grate/Burner • Grill U-Burner (E46GC67ESS only) Cap Pack • • • • Grill Heat Control Channels (E46GC67ESS • Burner Set • Gas Pressure • Grill (E46GC67ESS Regulator • LP Conversion • ) TT iiii)J;)i!i only) only) • Grease Control Box (E46GC67ESS Kit • only) CABINET/COUNTERTO
Preparingfor Installation HUII_Ix Plan the installation so that the electrical connection, gas shut-off valve, and pressure regulator are accessible from the front of the cabinet. Figure 1 iiiii!ii! 18.
Preparing for Installation Figure 3 (699m_) Figure 4 c_m D_=,_r_ FJ_ClISESS for t_ Figure 5
Making the Gas/Electric Connection i)iiii!iiii i!!!iiiiiiii_ REQUIREMENTS • • • • • • • • • • • • • • • • • • • • • • _i!!iii!ii_ii!ii GasSupplyRequirements iiii_!!ii_))ii) iiiiiiiiiiiiiili ii!i!i!i!_!_iiil Check your local building codes for the proper method of installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA 54.
Making the Gas/Electric Connection GasandElectrical SupplyRequirements The correct voltage, frequency and amperage must be supplied to the appliance from an isolated, grounded circuit which is protected by a properly sized circuit breaker or time-delay fuse. The cooktop must be connected to the power supply with copper wire only. The use of aluminum wire may result in unsatisfactory connections.
i i!!iiiiii! Installation INSTALLING THECOOKTOP !i;ii;i3i3!i • • • • • • • • • • • • • • • • • • • • • • Place and center the cooktop within the cutout. Secure the cooktop to the countertop utilizing the two (2) hold-down brackets provided. Do not overtighten the screws. See Figure 6.
_i!i]iiiiiiiii!ili Installation !iiiiii!_!!i!i GASANDELECTRIC REQUIREMENTS TABLE Refer to the following table for more information on gas and electric requirements. )ii)Jf_!iii! Gas type Manifold pressure Minimum gas supply pressure Natural 4" Water Column 5" Water Column Natural 4" Water Column 5" Water Column Natural 4" Water Column 5" Water Column E46GC67ESS Natural 4" Water Column 5" Water Column Above models converted to LP Liquid Propane Model No.
Installation INSTALLING THE BURNERCOMPONENTS • • • • • • • • • • • • • • • • • • • • • • BurnerComponents Remove the brass burner rings, porcelain burner caps, and porcelain grates from their shipping packages. Place each burner ring onto its corresponding burner base, being certain that the five alignment tabs slide into the matching notches in the base. Set each porcelain burner cap on top of its corresponding burner ring.
Installation MAKINGTHE ELECTRICALCONNECTION mmnmmmnmmmnnmmmmmu Plug the three-prong plug from the appliance polarized wall receptacle.
O,e=, on NNNINININNNNNNNNNIINNNNNNN _ _'__ __ _ VERIFYINGTHEOPERATION Before beginning the test procedure, ensure that the gas supply is turned off at the shut-off valve, all cooktop control valves are in the "OFF" position, and all burner i rings, burner caps, and grates are properly positioned on the cooktop. Rotate one knob at a t •me counterc ockw se to the Hi/LITE " pos "t on. Ver Iy that a II ignitors spark continuously, all knobs. See Figure 8.
iJiii_iiilJ!!ii Operation iiiiiiii_i_iii Turn on the main gas supply to the cooktop by opening the gas shut-off valve. Test each burner separately by pressing and turning one control knob at a time counterclockwise to the "HI/LITE" position. All ignitors will spark simultaneously. (It will take approximately four seconds for ignition to occur, at which time all igniters will stop sparking.
L_Electrolux