Installation Guide

5. Press“CLEAN”button“ ”，the icon lights up , 5 seconds later, this icon flashes, it will run cleaning

procedure for at least 20 minutes, then the icon goes out. Press this button again, it will stop

cleaning.

6. After cleaning procedure, move the appliance to the edge of the desktop, make sure that the

appliance is placed steady ,place a water container under the appliance, remove drain plug from the

back, unscrew the tie on the pipe, pull out the plug from the drainpipe, water in the tank under the drawer

and the evaporator will drain into the water container , then reinsert the plug and put it back again.

Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level. If the unit

isn’t to be used, drain all water & dry the water reservoir.

How to obtain the ice-cube

8. P

7. Before starting the ice making process, please check the drain pipe and drain pipe plug on the back

of the machine. Be sure to plug the drain pipe with a drain pipe plug and hang it on the back of the

machine.

ress the “ICE” button “ ”, the icon lights up , 5 seconds later, this icon flashes, it begin to work,

Press this button again, it will stop making ice. During ice making procedure, you can see how much

ice has been stored in the drawer through the observation window.

9. For the first time, or if the appliance has not been used for a long time, it is recommended to clean

this appliance before you start to make ice.

10. While the ice-maker is on, verify water level periodically. If water pump can’t pump out water, the ice

maker will stop automatically, and the

“Add water” indicator will on. Need to pour water into the water

reservoir inside.

We suggest you should press “ICE” button to turn off the unit first, then fill water up, again press

“ICE” button to restart the unit. Allow the refrigerant liquid inside the compressor at least 3 minutes to

settle before restarting.