Installation guide

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire air conditioner

Installation Instructions

READ BEFORE INSTALLING UNIT

MS II Window Mounting

YOur air conditioner is designed to install in standard

double hung wiudows with opening widths of 23 to 36

inches (584 mm to 914 ram) (FIG. 1)

Lower sash must open sufficiently to allow a clear vertical

opening of 14-1/2 inches (368 ram). Side louvers and the

rear of the AC nlust have clear air space to allow

enongh airflow throngh the condenser; for heat removal.

The rear of the unit must be outdoors, not inside a

building or garage.

Fig ]

NOTE: SAVE CARTON and these INSTALLATION

INSTRUCTIONS for future reference. The carton is the

best way to store unit during winter, or when not in use.

Some asse nbl5 s eqa ed. Please ead these last let ols

carefully.

Mounting Hardware

3/4"screws

lock frame

sash lock

Qty.

.......................... j/

When handling unit, be careful to avoid cuts

fronl sharp metal edges and aluminum fins on

front and rear coils.

Before installing unit, the top rail nmst be

assembled on the unit.

Top Rail Hardware Qty.

3/8" Screw 4

Top Rail 1

TOOL NEEDED:

• Phillips Scl'ewdriver

A, Remove the air

conditioner from the

cartou and place oil a

fiat surh,ce.

B. Remove top rail from

the bottom of the

packaging material as

shown m Fig. A

C. Align the hole in the

top rail with those in

the top of the unit as

shown in Fig. B

D. Secure the top rail to

the unit with the 3/8"

Sclvws as showu ill

Fig. C

Fig. A

Top Rail

TOOLS NEEDED:

• Phillips Screw Driver

• Drill (If pilot holes are ueeded/

NOTE: FOR SAFETY REASONS, ALL

FOUR (4) SCREWS MUST BE SECURELY

FASTENED.

P/N 66129901123

Summary of content (3 pages)

PAGE 1
Installation Instructions READ BEFORE INSTALLING UNIT MS II Window Mounting YOur air conditioner is designed to install in standard double hung wiudows with opening widths of 23 to 36 inches (584 mm to 914 ram) (FIG. 1) Lower sash must open sufficiently to allow a clear vertical opening of 14-1/2 inches (368 ram). Side louvers and the rear of the AC nlust have clear air space to allow enongh airflow throngh the condenser; for heat removal.
PAGE 2
How to Install NOTE: Top Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to tile rear must be maintained! Place unit on flooL\ a bench or a table. There is a Left and Right Window Filler Panel - be sure to use the proper panel for each side.
PAGE 3
Place the frame lock between the frame extensions and the window sill as shown (Fig. 8). Drive 3/4" through the frame (FIG. 9). NOTE: To prevent splitting, drill 1/8" (3 ram) driving screws. screws Cut foam seal and insert in the space between the upper and lower sashes (FIG. 13). (19 ram) locking lock and into the sill window sill from pilot holes before IfAC is Blocked by Storm Window Add wood as shown in FIG. 14, or remove window before air conditioner is installed.