Installation guide

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire air conditioner

u m

READ BEFORE iNSTALLiNG UNIT

Compact niWindow Mounting

Your ah"conditioner is designed to install in skmdard

double llm_g windows with opening widths of 22 to 36

inches (559 mm to 914 ram) (FIG. l)

Lower sash must open sufficiently 1oallow a clear velltical

opeuing of 14-1/2 inches (368 rnm). Side loovers and the

rear of the AC most have clear air space to allow

enoogh airflow throogh the condensel; for heat removal.

The rear of' the onit most be ootdoors, not inside a

boilding or garage.

NOTE: SAVE CARTON aud these INSTALLA-

TION INSTRUCTIONS tbr furore reference. The caJlon is

the best way to store unit during winter, or when not hi use,

When handling unit, be careful to avoid cuts

from sharp metal edges and aluminum fins on

front and rear coils.

Befbre installing the unit, the Left-Hand

Louver must be assembled to the unit:

A. Carefully remove power supply

cord flx)m air discharge area

(Fig. A).

B. Carefully remove dte Left-Hand

Louver Assembly from the

discharge area, and theu remove

it fl:om the plastic bag(Fig. B).

C. With care, pry apaJl tile auger

wheel shaft fl:om tile horizontal

k)uver casing, as shown hi Fig.

C,D&E.

Some assemNy is required. Please read these instructions

Mounting Hardware

3/4 'screws

lock frame

sash lock

TOOLS NEEDED:

* Drill (If pilot hales are needed)

Qty.

D. Now locate tile auger wheel

shaft into tile vertical ceuter

post (Fig. F).

E. Clip the oilier end hllo tile

locating slot.

E Now place the horizontal louver

casing onto the auger wheel

shaft, and snap in place (Fig.

G).

Check tile operation by moving

tile horizontal louver up and

down, and theu turn file auger wheel so file vertical

kmvers rotate.

SZOOO357(En) 1 , 10/21/2004, 10:42 AM

Summary of content (3 pages)

PAGE 1
÷ u m READ BEFORE Compact iNSTALLiNG ni Window Your ah"conditioner is designed to install in skmdard double llm_g windows with opening widths of 22 to 36 inches (559 mm to 914 ram) (FIG. l) UNIT Mounting When handling unit, be careful to avoid cuts from sharp metal edges and aluminum fins on front and rear coils. Lower sash must open sufficiently 1o allow a clear velltical opeuing of 14-1/2 inches (368 rnm).
PAGE 2
÷ How to Install NOTE: Top Rail and Sliding Panels a_teach side are offset to provide the proper pi_.eh to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch _.othe rear must be main_.
PAGE 3
Place the frame lock between the fi°ame extensions and the window sill as shown Cut _bam seal and insert in the space between the upper and lower sashes (FIG. 13). (Fig. 8). Drive 3/4" (19 nmO k)cking screws through the frame k_ck and into the sit1 (FIG. 9). NOTE: '[b prevent wh_dow sill from splitting, drill 1/8" (3 mm) pilot holes before driving screws. FIG. 8 IfAC is Blocked by Storm Add wood as shown in FIG. 14, or remove storm window before air conditioner is installed.