Installation guide

Installation Instructions

READ BEFORE INSTALLING UNIT

DESIGNER SERIES Compact II Window Mounting

"fOurair conditioner is designed to install in standard

double hung windows with opening widths of 23 to 36

inches (584 mm to 914 ram) (FIG. 1)

Lower sash must open sufficiently to allow a clear vertical

opening of 14-1/2 incbes (368 ram). Side louvers and the

rear of the AC nlnst have clear air space to allow

enough airflow through the condenser; for heat removal.

The rear of the unit must be outdoors, not inside a

building or garage.

When handling unit, be careful to avoid cuts

fronl sharp metal edges and ahlminum fins on

front and rear coils.

Fig. I

NOTE: SAVECARTON _xl these INSTALLATION

INSTRUCTIONS for future reference. The carton is tile

best way to store unit during winter, or when not in use.

Some asse nbl} s eql ed. Please ead these nst let ols

carefully.

Mounting Hardware

Qty.

3/4"screws

lock frame

sasb lock

TOOLS NEEDED:

• Phillips Screw Driver

• Drill (If pilot holes are needed/

.......................... j/

P/N 66129901129

PAGE 1
Installation Instructions READ BEFORE INSTALLING UNIT DESIGNER SERIES Compact II Window Mounting "fOur air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 ram) (FIG. 1) Lower sash must open sufficiently to allow a clear vertical opening of 14-1/2 incbes (368 ram). Side louvers and the rear of the AC nlnst have clear air space to allow enough airflow through the condenser; for heat removal.
PAGE 2
How to Install NOTE: Top Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to tile rear must be maintained! Place unit on flooL\ a bench or a table. There is a Left and Right Window Filler Panel - be sure to use the proper panel for each side.
PAGE 3
Place the frame lock between the frame extensions and the window sill as shown (Fig. 8). Drive 3/4" (19 nun) locking screws through the frame lock and into the sill (FIG. 9). NOTE: To prevent window sill from splitting, drill 1/8" (3 mm) pilot holes before driving screws. Cut foam seal and insert in the space between the ut)per and lower sashes (FIG, 13), IfAC is Blocked by Storm Window Add wood as shown in FIG. 14, or remove storm window before air conditioner is installed.