OWNER'S GUIDE READ AND SAVE THESE INSTRUCTIONS AIR CONDITIONER ROTARYCONTROL P/N 309000816 (9903)
ROOM Your AIR CONDITIONER product is protected WARRANTY by this warranty Your appliance is warranted by White Consolidated industries, Inc WCI has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this warranty WCI authorizes no one else to change or add to any of these ob ga ons under this warranty.
Product Registration Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On most models, the serial plate is located behind the left front louvers. Reading these numbers may be easier by using a flashlight or by removing the cabinet front as instructed under "Careand Cleaning." On somemodels, theserialplateislocated on the outside of the cabinet. Model No. Serial No.
Important Instructions electric shock. Safety from Avoid fire hazard or Do not use an extension plug. Do not remove the power cord. Grounding type wall receptacle under Power supply cord with 3- rong grounding p_urg Energy before using this air conditioner. For Your Safety Do not store or use gasoline or other flammable vapors and liquidsin the vicinity of this or any other appliance. Read product labelsfor flammability and other warnings.
Front Installation Installing Bottom Rail Seal (some models) Some models are shipped in a removable sleeve that must be positioned propedy for safe and efficient sealing. Follow the Installationinstructions supplied. To installthe Bottom Rail Seal, position the seal on top of the bottom rail, flush with the front edge of the rail and in contact with the side seals. Manual Vertical Louver Adjustment (side air discharge) Complete this adjustment before installing front panel. 1.
Front Installation Installing Dial Plate and Front Frame Some models require installation of the dial plate and the front panel of the air conditioner included in a decorative kit. To assemble, follow these steps. (continued) STEP 1: ..... INSTALL DIAL PLATE AND BUTTONS OR KNOBS: o Remove control knobs from front kit (some models). • Carefully remove protective film from the front of the dial plate (some models).
To reduce the risk of fire, electdc shock, or inJu ry to persons, Using Air Conditioner IMPORTANT SAFETY iNSTRUCTIONS To begin operating before the air conditioner, operating follow 1. Plug in the air conditioner. (To prevent extension cord or an adapter plug.) NOTE: If the air conditioner is turned off, wait 3 minutes before restarting. This I 2. allows pressure inside the compressor to ! equalize. Failure to follow these I 3. 4. instructions may cause inefficient operation. 5. 6.
Air Conditioner Features continued) Air Directional Louvers Air directional louvers control air flow direction. louver types described below. You r air conditioner has one of the 2-Way Louvers Louvers at the top front of some air conditioners permit side-to-side adjustment of airflow direction. Move the levers to direct air to either the left or right. The left lever adjusts the left half of the louver and the right lever adjusts the right half of the louver.
Care and Cleaning cont. • • --[ ] • 6-waylouver models have a slide out filter. Grasp the formed handle of the filter and pull it to the left, removing it from the front panel (Figure 2). For most installations in the window, this front may need to be removed to access the filter for cleaning (Figure 3). To remove the front, reverse the installation process for Side Air Discharge Models shown in Front Installation.
Avoid Service Checklist Before calling for service, review this list. It may save you time and expense. This tist includes common occurrences that are not the result of defective workmanship materials in this appliance. OCCURRENCE SOLUTION Air conditioner will not operate. Wall plug disconnected or Push plug firmly into wall outlet. House fuse blown or circuit breaker tripped. Replace fuse wit h time delay type or reset circuit breaker.